e82 n54 Post Cat Oxygen sensor ripped

[dsocold]

as the title states driving through the snow got the best of me and ripped both of my post cat oxygen sensors clean off, one i was able to connect again but the other one was done it ripped out the wiring and connector so a new o2 sensor doesnt just fix the issue.

is there a way i can remove the 2c9f code somehow.
I run MHD you cant flash it out i doubt it. Do they have any repair kits of any sort?.
honestly the check engine light bothers me so i would love to have it turned off somehow without spending to much...

[dsocold]

bump anyone?

[titium]

easiest and best solution is to just replace the sensors.

you can probably get rid of the codes in a tune but means you'll always need a custom tune.

post cat 02s also make sure the pre cats o2s are working correctly

[dsocold]

Originally Posted by titium

easiest and best solution is to just replace the sensors.

you can probably get rid of the codes in a tune but means you'll always need a custom tune.

post cat 02s also make sure the pre cats o2s are working correctly

yea but its more to it then that becuase the wiring that goes to one of the sensors is ripped out pretty deep as well because i only see one wire where i imagine there should be 3 coming out of the harness that supplies the wiring and connector needed so that you can plug the o2 sensor in