|
|
|
09-14-2016, 02:04 PM | #1 |
Colonel
2182
Rep 2,805
Posts |
Strut assembly question
I'm putting together struts to replace the current ones. I have nearly all the pieces to completely assemble the struts so I can just remove & replace the existing ones.
My question is regarding parts #6 and 7 in this parts diagram: http://www.realoem.com/bmw/enUS/show...diagId=31_0695 I'm nearly sure that #6 goes on in such a way to 'cup' the bearings on the guide support. Part #7 is a slightly convex 55mm washer with a darker ring near the edge (I couldn't upload a photo for some reason). It seems to make more sense with ring side up i.e. against the cupped washer and the flat side against the upper spring plate. Anybody know if this is correct? |
09-14-2016, 03:23 PM | #2 | |
Lieutenant
121
Rep 505
Posts |
Quote:
|
|
Appreciate
0
|
09-14-2016, 04:47 PM | #3 | |
Colonel
2182
Rep 2,805
Posts |
Quote:
That makes sense for the ringed washer from putting it together loosely. Many thanks! |
|
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|