|
|
|
07-12-2014, 07:28 PM | #1 |
Second Lieutenant
19
Rep 269
Posts |
exhaust BOLTS spring loaded
Hi
I am fitting my agency power exhaust today and was wondering how tight do the spring loaded exhaust bolts have to be - do you take them all the way until you hit the stop , or should they be backed off to allow for thermal growth? thanks JD |
07-12-2014, 11:50 PM | #2 |
Lieutenant
54
Rep 472
Posts
Drives: Volvo S60 R-Design Polestar
Join Date: Mar 2014
Location: Melbourne, Australia
|
|
Appreciate
0
|
07-13-2014, 05:54 AM | #3 |
Colonel
171
Rep 2,682
Posts |
On my aftermarket exhaust I don't even have spring bolts, just bolt, but and washers.
You shouldn't crank them all the way to the end though. There is a specific torque rating you are meant to tighten it to but you'll need the BMW TIS or Bentley manual to know that.
__________________
|
Appreciate
0
|
07-13-2014, 07:43 AM | #4 |
Lieutenant
114
Rep 537
Posts |
From BMW TIS for an E92 N54, gotta be the same for E82...
18 00 exhaust pipe with catalyst / system assembly Type Thread Tightening Value 1AZ assembly of the exhaust system to the connecting pipe with catalyst N54 M8 21 Nm 2AZ assembly of the exhaust system to the rear wheel bearing N54 M8 21 Nm 3AZ connecting pipe with catalyst to the exhaust turbocharger N54 M8 x 40 13 Nm 4AZ assembly of the exhaust system to the gear of the rear wheel N54 AM12 30 Nm 5AZ clip 45 Nm
__________________
2020 MY21 BMW M2 Competition 6MT | Black Sapphire OLD 2010 BMW 135i M Sport 6MT | Le Mans Blue 2016 BMW F15 X5 30D | Sapphire Black | Black Leather |
Appreciate
0
|
07-14-2014, 01:02 AM | #5 | |
Second Lieutenant
19
Rep 269
Posts |
Quote:
JD |
|
Appreciate
0
|
07-14-2014, 01:03 AM | #6 |
Second Lieutenant
19
Rep 269
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|