|
|
|
03-07-2016, 11:21 PM | #1 |
Second Lieutenant
47
Rep 246
Posts |
Used JB4 installed - do I need to tweak user settings?
I have searched and read a bunch, but am not sure what the answer is to my issue. I have a 2012 135i DCT. Just picked up and installed a BMS intake and a JB4. I did the ISO update. What I am not sure about is what all my user settings need to look like. I think the unit was used on a 335 b/c I had to set the gauges to work correctly on my 135. The values in the user settings don't all match those shown on page 1 of the ISO update thread AT http://www.n54tech.com/forums/showthread.php?t=17800 . Do I change these to match the screen shot there, or something else?
I am not going to be a pro user. I just want the car to be fun to drive and not fry anything. Car has 96K miles so I am nervous anyway. WOT Map 5 scared me! Got the same flash as the warmed up flash also. Not sure what that meant. Please forgive the noob-ness here and apologies if I have missed an obvious answer somewhere. Thanks! |
03-08-2016, 08:32 AM | #2 |
Colonel
707
Rep 2,448
Posts |
Yes you should update to the settings on that thread. I would zero out afr bias as it's not used on the n55. If you are running the stock flash I believe you need to choose setting 4 (tach)/3 (speedo), but I would confirm on n54tech. The best thing to do is start a thread in the support section of n54tech. No matter what you are going to have to log to confirm everything is in check. After that you should be good to go.
|
Appreciate
0
|
03-10-2016, 01:54 PM | #3 | |
Second Lieutenant
47
Rep 246
Posts |
Quote:
|
|
Appreciate
0
|
03-10-2016, 02:48 PM | #4 | |
Second Lieutenant
47
Rep 246
Posts |
Quote:
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|