|
|
|
02-02-2017, 02:35 PM | #1 |
New Member
5
Rep 20
Posts |
JB4 - Auto Delete Codes Off mode
How do I know if I am in the correct mode. I went to the steering wheel controls and chose 1-4 and now when I go back to 1 on the speedo the tach reads at 0. Is that what it should be doing? At have a catless downpipe and was expecting it to throw a code when I switched it to 1-4 but the CEL has not come on yet. I only changed it to auto delete off yesterday.
Thanks |
02-02-2017, 03:32 PM | #2 |
Private First Class
135
Rep 134
Posts |
You might have to drive a complete driving cycle to have the code reappear, ie drive until the engine is fully warmed up.
__________________
2016 435i xdrive Gran Coupé
2011 E82 1M Custom Frozen Brilliant White 2006 E60 M5 Alpine white SMG DELETE 6MT swap. Gone : 135i 2008 | Gone : 2008 535i Touring| |
Appreciate
0
|
02-02-2017, 08:47 PM | #3 | |
General
903
Rep 1,003
Posts
Drives: 2008 BMW 135i (E88 N54 6AT)
Join Date: Aug 2016
Location: Sunshine Coast QLD Australia
|
Quote:
Just to hijack your thread - I also often get 2C77, 2CA8 and 2C7B codes "Lamdba probe behind catalytic converter (1&2) signal / function" errors. (these are also autocleared) I'm assuming this is because they were damaged during the install of the downpipes.... does anyone know if this error can be safely ignored? |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|