Sponsored by The Tire Rack

[uberschnell]

I've searched, and now I'm asking if anyone has done ET35 wheels up front and lived to tell about it. Need to see if it's possible on a dropped car.

I'm willing to roll the fenders, grind the tabs and am running camber plates.

Looking at an 8.5 wide wheel.

So what says you?

[cooler2442]

ET37 up front atm on 19x8.5. But offset is an estimate since ADV 1 doesn't give them out specifically.

[maupineda]

I do, however my wheels are 8in wide front and rear. It used to rub but a bit of camber was enough an I am lowered on H&R sport springs. 8.5 will rub badly as I barely has clearance, I have 225 tires

[Joaco135]

I run 215 on 8" also lowerred on H&R Sport and only rub on big dips at fast speed, other than that is fine. I haven't roll the fenders either.