FS: Custom Muffler Delete (Nor Cal)

[Top Gon]

I'm selling my custom made muffler delete. I had it made a couple years ago at a local exhaust shop. It was an experiment back then, but I liked it so much that I kept it on. It's not mandrel bent or anything, but it is aluminized steel I believe. It's made to fit the stock exhaust flange, so it will require that you cut the flange from the stock exhaust or get one made.

Reason I took it off is because I just installed downpipes and it's way too loud with a muffler delete.

It's 2.5in piping and weighs no more than 10lbs (can be easily lifted above the head with 1 hand lol.)

My asking price is $100 or BEST OFFER.
Also, I would prefer not to ship it, but I can look into it if I really have to.

PICS:







and VIDEO:

[Top Gon]

Ttt

[Top Gon]

price reduced to $75 OBO

[1911A145]

It's not stainless steel. That's for sure. It is aluminized steel. stainless is too soft to bend and would literally "crush" in a crush bender. Either way, aluminized is good for around 5-8 years depending on the climate usually.

GLWS.

[Top Gon]

Originally Posted by 1911A145

It's not stainless steel. That's for sure. It is aluminized steel. stainless is too soft to bend and would literally "crush" in a crush bender. Either way, aluminized is good for around 5-8 years depending on the climate usually.

GLWS.

ahh thanks for the info. Yeah, I don't see it rusting or anything. California weather is good. Like I said, this was experimental so I wasn't expecting it to last forever

[MunichMike]

Any close up pics of it on the car? I'd like to see the fitment

[Top Gon]

Originally Posted by Mike Hundreds

Any close up pics of it on the car? I'd like to see the fitment

It sits facing the left slightly (on purpose) kinda like an e30 3-series exhaust.
I'm sure you can tweak it a bit tho when you weld a flange on it.