What is this part on the bumper???

[kb135]

Hi. Does anyone happen to know what the blackout sections are on the bottom of this bumper? I am after a similar thing for my 135i and I have no idea what its called or where to source it.

I don't believe it is called a splitter or lip because those seem to be usually a big single

piece spanning right across the front bumper at the lip section. This is a two-piece part. Any ideas guys?

[Sylon]

Those look like CF splitters, however I couldn't tell you the name. You might have better luck asking on the 3series forum.

[JYohay]

fyi a lip is a large fill width add on.
splitters are when its 2 smaller pieces like in the picture.

[Boxtyp3]

A lip is one piece spanning from end to end of the bumper. A splitter is a lip split in to two. Hence the name.

[Joaco135]

Scopione makes a Carbon Fiber Splitters for the 135, check their website
www.scopioneusa.com

[kb135]

Thanks to you all. I appreciate the replies. I knew there must have been a name for those ;-) was right under my nose....