| 06-11-2017, 10:21 AM | #1 |
|
New Member
16
Rep 16
Posts |
New car need help for setup single turbo 6266
Hello every one I'm new in this forum I have 2010 135i automatic stock motor I would like to install single turbo from Doc race 6266 but I'm confused what kind of setups do I need for the engine to run the single turbo safely ?
And what about the AD engineering 1000hp intercooler anybody have any review? Or better intercooler? |
| 06-12-2017, 11:41 AM | #2 |
|
Colonel
 
2616
Rep 2,819
Posts
Drives: e82 1M, f87 M2cs
Join Date: Nov 2011
Location: Tri-Cities, Washington
|
I use AD Engineering's smaller inercooler, which is the same but with a 1" step instead of a 3" step, and have been very happy wioth results. They fitted it themselves. It requires cutting the shroud, but not the bumper cover itself.
__________________
1M track toy mods: BMS chargepipe, BMS OCC, ADE FMIC, ADE motor mounts, MadDad/Lightweight Ti exhaust, ADE custom oil thermostat/cooler, custom MHD tune, F10 550i clutch, Ohlins R+T, Vorschlag camber plates, M3 'vert FSB with Turner endlinks, Stoptech Trophy BBK.
|
|
Appreciate
0
|
| 06-12-2017, 11:47 AM | #3 | |
|
New Member
16
Rep 16
Posts |
Quote:
|
|
|
Appreciate
0
|
| 06-14-2017, 04:36 PM | #4 |
|
Second Lieutenant
 
48
Rep 231
Posts |
I use the AD Engineering 1000hp core and have never had an issue. I would highly recommend it. It used IC Cores from Garrett Turbos which is a plus!
__________________
|
|
Appreciate
0
|
Post Reply |
| Bookmarks |
| Tags |
| 6266, ad engineering, setups |
| Thread Tools | Search this Thread |
|
|
