UberWagon's 1M Clubsport Build aka The BlackKnight Returns!

[PRTSB1M]

Originally Posted by UberWagon

PRTSB1M Did you ever get your dual x240 mounts installed? I am looking to replace my originals and curious if you had a review yet.

Sadly, not yet and it might be a while before I can get them in. Many plans have gotten pushed back due to covid and recovering from a bad elbow break. Thankfully the car runs great and I can still drive it

[UberWagon]

Had a leak developing at the oil pan and decided I would go full "while you are in there" and install an Advanced Auto Fab oil pan baffle while I had it all pulled apart. This is one where the labor is waay more than the cost of the parts, but now I have a fresh gasket, no leaks, and some more piece of mind on track.

[CarJunkie]

Originally Posted by UberWagon

Had a leak developing at the oil pan and decided I would go full "while you are in there" and install an Advanced Auto Fab oil pan baffle while I had it all pulled apart. This is one where the labor is waay more than the cost of the parts, but now I have a fresh gasket, no leaks, and some more piece of mind on track.

I wish I had your time and talents! I DIY most work in my track cars, but welding in the oil baffle? No thanks!

ADE is 30 minutes away so they did my tuning, FMIC and oil cooler setup …. Nice to have a shop like that nearby.

Advanced Auto Fab is 2 hours away, so I would probably let them do this for me if I decide to get the baffle.

[UberWagon]

Originally Posted by CarJunkie

I wish I had your time and talents! I DIY most work in my track cars, but welding in the oil baffle? No thanks!

Full disclosure: I got some help from a local race shop on this one. While I can lay some pretty ugly MIG beads on thick steel, I bring in the pros for the aluminum bits!