|
|
|
04-27-2013, 05:49 PM | #1 |
Lieutenant
99
Rep 508
Posts |
Need help please!
I just replaced my valve cover gasket and followed a DIY. Car started fine and I took it for a test drive. Once warm I gave it some gas and it threw a engine malfunction and a DTC error???
Only code pulled was 2A97 Crankshaft sensor, gap failure Could this be due to a bad gasket install? and loosing pressure? I tightened everything down to 7lbs but feel this might not be enough... Any guidance would be appreciated. Regards, |
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|