|
|
|
08-12-2013, 07:53 PM | #1 |
Major General
456
Rep 6,478
Posts |
So how will I fit a front lip with a 7" FMIC?
It's a large core so it protrudes down a bit, and the bumper bulges a bit to accommodate it. I've worked up the stupidity to strap a lot of money to the front bumper while DD'ing in DC, so how will it fit? Just eyeballing it, i'm not sure how it'll fit flush
__________________
E88 N54 Alpinweiss/Coral Red/Motiv HTA 3586r Tial .82AR/Other stuff...652WHP
F30 N55 XDrive EBII |
08-13-2013, 02:51 PM | #2 |
Major General
456
Rep 6,478
Posts |
No one has a front lip with 7" Intercooler?
__________________
E88 N54 Alpinweiss/Coral Red/Motiv HTA 3586r Tial .82AR/Other stuff...652WHP
F30 N55 XDrive EBII |
Appreciate
0
|
08-15-2013, 01:58 PM | #4 | |
Major General
456
Rep 6,478
Posts |
Quote:
So the lip fit fine even though your bumper had a bulge downwards in the middle? Or was your bumper totally level to begin with. The ER core is 7", so the dimensions should be almost identical to mine. I just see a bulge that would appear to make it tough to fit the rigid lip to the edges of the bumper.
__________________
E88 N54 Alpinweiss/Coral Red/Motiv HTA 3586r Tial .82AR/Other stuff...652WHP
F30 N55 XDrive EBII |
|
Appreciate
0
|
08-15-2013, 05:38 PM | #5 |
Captain
326
Rep 914
Posts |
Are you sure you installed the FMIC correctly? I don't have one but plan on it in the future. From what I've seen on install instructions there shouldn't be any bulge. I could be wrong though
|
Appreciate
0
|
08-15-2013, 09:21 PM | #6 |
Major General
456
Rep 6,478
Posts |
It's a 7" core so it's appreciably larger than stock. With that said, it was a V1 piece from VRSF, perhaps the mounting tabs are welded on a bit high up on the core, making it sit artificially low. I need to take the bumper off and investigate, I haven't looked in there for months (no reason to).
__________________
E88 N54 Alpinweiss/Coral Red/Motiv HTA 3586r Tial .82AR/Other stuff...652WHP
F30 N55 XDrive EBII |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|