Where to buy intake (Diverter Valve) plug/caps

[siegester]

Where might I find a 5/8" plug or cap so that I can vent the diverter valves to the atmosphere?

I've checked all the local auto parts stores and they only go up to 3/4" bypass caps.

Thanks!

[ErvGotti]

Home depot or lowe's, ask them for the rubber caps that go on to chairs to protect the floor.

[siegester]

Thanks!

I'm going to try and find a pack of these tomorrow.

[Turbolader]

I'm glad I'm not the only one that heads to Lowe's for go-fast parts.

I kid you not, the oil return line for my srt4 is a piece of a faucet water line

[ErvGotti]

Originally Posted by cjof2003

Thanks!

I'm going to try and find a pack of these tomorrow.

Yup those are the one's I run.

[Dackelone]

a solid piece of a metal dowl cut down would work too. Or have a machine shop mill you a round metal "stopper" plug.

[siegester]

Ok got these put on. Man getting to the back one was harder than I figured it would be. Ended up removing the cabin air filters and the entire cowl as it was locked on there pretty good.

Is there any non-permanent way to remove the flex tubing from the diverter valves now? I zip tied them out of the way for the time being, but I'd rather clean up the job more than that.

If not, no biggie as this is not a good solution for me. Call me a ricer, but these aren't nearly loud enough for me. Granted my last two BOVs were a TurboXS RFL and HKS SSQV.

Looks like I'll be asking the wife for a charge pipe for my HKS SSQV for Xmas...if I can wait that long