|
|
|
01-11-2011, 11:41 AM | #1 |
Captain
123
Rep 905
Posts |
Question on firmware updating on JB4
I sent Terry an email and am awaiting his response. BUT, I figure this might be something stupid I missed or what not. I followed the directions based on updating firmware on JB3, but couldn't get the interface to connect with out the car started. So once started and connected, I got it to upload to 100 out of 400 and then the car died and it stopped uploading. I did not think there was a way to connect to JB4 via interface without the car started? Now it says I have no firmware and to upload it before starting the car? Any ideas and thanks in advance.
|
01-11-2011, 12:59 PM | #3 |
aiming for 450.....
303
Rep 2,910
Posts |
lol. It happens to the best of us...
__________________
Quote from Ezeedee regarding car mods:
"you're only done when you sell the car " |
Appreciate
0
|
04-21-2011, 12:17 AM | #4 |
Private
4
Rep 64
Posts |
I had the same thing happen to me too no interface intill start engine. I found out here and try with engine started and it work. other wise i couldn't have for life of me wouldn't work any other way. So i started with engine running, it will kill the engine automatic then contuine on with upload on the latest firm ware. finally got to work.
__________________
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|