|
|
|
11-21-2013, 11:16 PM | #1 |
Private
3
Rep 55
Posts |
lux angel eye install problem
I tried installing my angel eyes today but it was only a tease because a minute later I got the headlight error. Is anyone in the central jersey area that has done this error free and would be able to help me install these bad boys one day? I will pay in beer
|
11-22-2013, 01:54 PM | #4 |
Colonel
171
Rep 2,347
Posts |
Yeah this happened to me when I installed mine. I took it out and used 3m double sided tap to anchor the box to the housing cover. It's a pain in the ass GL OP
__________________
Mods:-Berkexhaust -alpinaB3flash -CobbAP -Cobb FMIC -ER charge pipe tialQ bov -M3 front sway bar -M3 subframe bushings -M3 front upper and lower control arms -M3 guide rods -M3 rear upper control arms -Mfactory LSD -defiv lockdown kit -TC Kline SA coilovers /camber plates- HP rear toe arms |
Appreciate
0
|
11-22-2013, 02:12 PM | #5 |
The Crowing
111
Rep 2,005
Posts |
happened to me, dealer had to replace igniter, motor and headlight bulb. very expensive. it wasn't because the LED i put in. it stayed there even after putting the stock bulbs back in. the balast must have fell down and got stuck in there. i ended up getting velcro and velcroing it to the headlight backing. kinda like the other idea with tape. i hope everything works out with you. good luck.
__________________
2009 135i : BMS JB4 G5 ISO,CXRacing FMIC Kit,Injen Cold Air Intake,Evolution Raceworks Charge Pipe,Walboro Inline Fuel Pump, E85 BMS Backend Flash w/ 60% E85,BMS Meth injection (trunkmount),BMS dual meth nozzles,Spec stage 2+ clutch w/ steel SWFW,BMS Catless Downpipes,Berk Tech Race Axleback |
Appreciate
0
|
11-22-2013, 02:48 PM | #6 |
Private
3
Rep 55
Posts |
thank you guys both for the advice. I tried attaching it to the back of the housing cover, but its not even so the velcor wouldn't stay any other idea? may try to reinstall this tomorrow.
|
Appreciate
0
|
11-23-2013, 02:03 PM | #7 |
Colonel
171
Rep 2,347
Posts |
Did you try the 3m?
I tried Velcro first and had no luck with it.
__________________
Mods:-Berkexhaust -alpinaB3flash -CobbAP -Cobb FMIC -ER charge pipe tialQ bov -M3 front sway bar -M3 subframe bushings -M3 front upper and lower control arms -M3 guide rods -M3 rear upper control arms -Mfactory LSD -defiv lockdown kit -TC Kline SA coilovers /camber plates- HP rear toe arms |
Appreciate
0
|
04-01-2014, 11:19 PM | #10 |
Private
3
Rep 55
Posts |
So I tried to install them again and again it was an EPIC FAIL does anyone know of any shops that can help me out or would anyone be willing to lend a desperate fellow a helping hand?? I'm located in central jersey also in the Trenton area
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|