|
|
|
07-29-2010, 02:32 PM | #1 |
Private First Class
14
Rep 198
Posts |
Front M3 arb on a 1er
Im sure someone has done this mod. Im from the UK and have had the rear subframe bushes installed. I have bought the front M3 tension rods and wishbones ready to go on when the tires run out of tread so i can get it all tracked up at once, but as i was doing this i thought why not get the front M3 ARB done at the same time. My question is:
Does anyone have the part numbers for the ARB and are there additional bits required along with the arb to allow it to fit the 1 series. It will probably be a couple of weeks before this is done so i have enough time to order the bits required and get the car booked in to get everything fitted. Thanks in advance. |
07-29-2010, 02:58 PM | #2 |
Lieutenant
40
Rep 400
Posts |
what's an ARB?
__________________
Black Sapphire Metallic 135i/Coral Leather Interior/ Gloss Black Grills/20% tint/M door sills/Black 135i badge, smoked LED side marker, Dinan stage II , DINAN Exhaust, performance side skirts, performance shift boot/e-brake, pedals, carbon fiber wrapped interior
|
Appreciate
0
|
07-29-2010, 03:03 PM | #3 |
Colonel
37
Rep 2,084
Posts |
Yes, additional parts are required.
The part numbers are probably somewhere in this long thread. http://www.e90post.com/forums/showthread.php?t=177028 If you were in America, I'd say just order this kit. http://www.hpashop.com/product.sc?pr...categoryId=119 |
Appreciate
0
|
07-29-2010, 03:35 PM | #5 |
Major General
159
Rep 5,689
Posts |
I have it and like it
__________________
Legal Disclaimer: Anything I or anyone else says about my vehicle on this website(1addicts.com or any affiliated or nonaffiliated sites), pertaining to modifications, is only to gain acceptance from my/our peers, and does not actually represent anything actually existing on my car, and thus, cannot be held against me in any issues, i.e. warranty claims, that may arise.
|
Appreciate
0
|
07-29-2010, 09:02 PM | #6 |
Private First Class
14
Rep 198
Posts |
Thanks very much for the link, got the part numbers i needed. Glad i asked otherwise i would have been in a bad position come install time
|
Appreciate
0
|
07-30-2010, 12:34 PM | #7 |
Private First Class
14
Rep 198
Posts |
For those 1 series owners who have fitted the anti roll bar, did you use the swing support link rods also?
Im not sure if i will need this or not. Thanks. |
Appreciate
0
|
08-08-2010, 02:12 AM | #8 |
Supreme Allied Commander
3839
Rep 54,348
Posts
Drives: F80 M3
Join Date: Mar 2007
Location: Santa Barbara, AP, Brembo, GIAC, Koni, Ohlins, Performance Friction, www.hpautosport.com
|
No, you do not need the swing support links from the M3, they are too long and were made to fit the M3 strut specifically.
|
Appreciate
0
|
08-09-2010, 07:08 AM | #9 |
Private First Class
14
Rep 198
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|