|
|
|
05-24-2018, 06:41 AM | #1 |
RetNavSpook
67
Rep 398
Posts |
ODB-II Power
When a device, in this case a Dash Command module, is connected to the ODB-II port does it draw power when the car is turned off? There are no lights to indicate that it is drawing power.
|
05-24-2018, 09:03 AM | #2 |
Sideways and Smiling
3027
Rep 2,860
Posts
Drives: In Exuberance
Join Date: Mar 2017
Location: Rosamond, CA USA
|
I don't think so, I think they're only powered when the ignition is on or recently turned off...
__________________
2012 BMW 328i 6-Speed Wagon | Deep Sea Blue with Grey Dakota Leather | Manual Swap, 330i Intake + Tune, 3.15 Helical LSD, Öhlins R&T
(SOLD) 2009 BMW 128i 6-Speed Coupé | Monaco Blue with Black Sensatec | chris_flies' 128i thread |
Appreciate
0
|
05-24-2018, 09:55 AM | #4 |
Captain
368
Rep 650
Posts |
I have a Scan Gauge II plugged in full time. It shuts down a few seconds after ignition and does not come to life until a few seconds after the ignition is turned on again. This has been in place for three years and I have noticed no battery issues I would attribute to the Scan Gauge
|
Appreciate
0
|
05-24-2018, 10:56 AM | #6 |
Brigadier General
3475
Rep 3,722
Posts |
It turns off, I have a Carly unit that shows when it's getting power. It blips on when i walk near the car with my key though so be aware of that if you have CA
__________________
"Tobias" 2013 135i ///M-Sport 6MT • Pure Stage 1 • XDI 35 HPFP • 404whp/440wtq |
Appreciate
1
YearOneOne360.50 |
05-24-2018, 11:26 AM | #7 |
Captain
361
Rep 727
Posts |
|
Appreciate
0
|
05-24-2018, 03:37 PM | #8 |
RetNavSpook
67
Rep 398
Posts |
Tks to everyone who responded. This puts my mind at ease. I also assume, and we know what the means, that the two pronged plug for an apple device also shuts down when the ignition is off. Tks again.
|
Appreciate
1
chris_flies3027.00 |
Post Reply |
Bookmarks |
|
|