|
|
|
04-27-2009, 03:23 PM | #1 |
Captain
35
Rep 717
Posts |
KW front suspension installation help
Hi,
I'm trying to install my KW suspension with Vorshlag camber plates right now and the front suspension is touching the OEM roll bar after tightening it down. Is this going to cause issues for me in the future? Thanks! |
05-07-2009, 12:48 AM | #5 |
Lieutenant Colonel
223
Rep 1,565
Posts |
I think you may have the damper reversed. IIRC they are labeled for the L/R sides. It should not make contact with the nut/stud. Or maybe you have the end link on the wrong side?
Also make sure that you slid the damper all the way into the little alignment tab they have. It'll slide into the slot on the upright. |
Appreciate
0
|
05-26-2009, 04:10 PM | #7 |
Second Lieutenant
15
Rep 226
Posts |
are you sure you mean touching the roll bar, or touching the strut brace in the engine compartment? Some people also reported the same problem with the strut brace with the early design of the Vorshlag plates....
|
Appreciate
0
|
07-05-2009, 03:07 PM | #9 | |
Second Lieutenant
22
Rep 291
Posts |
Quote:
Thanks in advance... |
|
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|