|
|
|
11-17-2011, 01:40 PM | #1 |
Second Lieutenant
18
Rep 254
Posts |
Trusted Shop to Install M3 Parts in DFW
I've accumulated quite a few M3 parts and I am ready to get them installed -- can anyone recommend a quality shop I can go to?
I was thinking Stett or Autoscope -- but I'd like to hear from some forum members who have actually had m3 parts installed somewhere in Dallas. Thanks in advance, Matt
__________________
cdv delete | clutch stop | bmw performance ssk | meisterschaft gt | berk mids | dinan cai | helix fmic | m3 subframe bushings, swaybar, front and back suspension bits | dinan stage 1 suspension | dinan cf strut brace |gc camber plates | dinan oil cooler | apex ec-7s w/PSSs | cobb stage 1 + fmic
|
11-18-2011, 12:37 AM | #2 |
Private
5
Rep 65
Posts |
I have heard several good things about Autoscope. I used them to roll the fenders on my old car and was please with the job they did. Staff was very courteous and their shop looked great.
|
Appreciate
0
|
11-18-2011, 08:46 AM | #3 |
Colonel
105
Rep 2,696
Posts |
You may have a bit more luck with this kind of question on the regional forum on here and on the e9x regional forums.
__________________
Faster, faster, faster, until the thrill of speed overcomes the fear of death… – Hunter Thompson
|
Appreciate
0
|
11-22-2011, 05:56 PM | #5 |
Cone Cruncher
31
Rep 534
Posts |
FYI, the conversion isn't difficult, but it is very time consuming. I don't live in the area, but I'd recommend going somewhere that does a lot of BMW work as the tools should be common.
Afterwards, you will need an alignment and that is where I would take it to a shop that does alignments and track inspections. Get both done at the same time to double check the work and make sure you are safe. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|