|
|
|
06-06-2011, 12:03 PM | #1 |
Joint Chiefs of Staff
4914
Rep 115,980
Posts |
JB4/FSB Integration
Hey guys,
Quick photo here showing how the FSB connects in to the JB4 harness. Extremely simple and clean! Just one wire runs out of the DME box to the solenoid/pump which grounds on the bracket and you're good to go. The JB4 then runs the meth pump and solenoid directly based on RPM, boost, throttle, timing advance, map selection, etc. It also gets flow/load information from the FSB which is used for the progressive meth mapping/safety and can also be displayed in dash. They have 10 alpha testers lined up and hope to have everything ready for the general public shortly after that testing is wrapped up. In addition to the WW kit (windshield washer kit) the FSB integration can be used with virtually any meth pump or kit. Alone it will retail for $150 with the JB4/N54 wiring preinstalled or $125 with bare wires. They will also be offering all the popular CM tank kits with the FSB alone at a considerable savings over the CMGS/VC2 kits for those who prefer trunk mount to WW mount. |
Post Reply |
Bookmarks |
|
|