|
|
|
05-15-2017, 09:23 PM | #1 |
Enlisted Member
3
Rep 36
Posts |
Vanos solenoid cleaning - help
Hey guys
I have a bmw 135i with the n54 engine, I had a code come up few weeks ago which was 2A87 Outlet-Vanos variable cam control test and 3100 boost-pressure control, deactivation After a bit of research found out it was the exhaust solenoid and the 3100 code was limp mode pulled out both intake and exhaust solenoid (one by one) cleaned them with CRC Brakleen but did not clean them with an air compressor as I have seen some people do. After putting them back in, car ran perfectly normal again, maybe even better (even on WOT) but then night time fell, driving normal, engine light came on. Would you say I did not clean them correctly or they would need to be replaced? Thanks guys |
05-15-2017, 10:24 PM | #2 |
Brigadier General
1493
Rep 3,148
Posts |
I have not had much luck cleaning them. I ended up replacing mine.
__________________
|
Appreciate
0
|
05-16-2017, 07:49 AM | #4 |
First Lieutenant
117
Rep 376
Posts |
I had the exact same code. Cleaned them and it fixed it for a week before the code came back again. Just replace them. They're not expensive and it's a really simple job.
I bought some cheap Chinese ones from eBay for about $60 each that have a 3 year warranty. They have been perfect so far for the last 8 months or so. |
Appreciate
1
1three5e822.50 |
05-18-2017, 08:22 PM | #5 | |
Enlisted Member
3
Rep 36
Posts |
Quote:
|
|
Appreciate
0
|
05-19-2017, 01:47 AM | #6 |
Colonel
171
Rep 2,682
Posts |
I cleaned mine with a little compressed air can and reinstalled them. Been fine for 3-4 years since.
__________________
|
Appreciate
0
|
05-19-2017, 06:12 AM | #7 |
First Lieutenant
117
Rep 376
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|