Most professional and high quality Meth Setup?

[dh58]

I know that Advan has the most stealth setup. However, what is the most professional and high quality meth setup?

I just saw the M4 GTS has it setup, there aren't many pictures of it. It too is in the trunk so I am intrigued.

Thanks!

[DR-JEKL]

Aquamist HFS4

[dh58]

Originally Posted by DR-JEKL

Aquamist HFS4

Thank you!

Any other recommendations or suggestions?

[totti84]

Originally Posted by dh58

Thank you!

Any other recommendations or suggestions?

You asked for the best, HFS4 is the best!

Coolingmist/BMS and Snow Performance are some other options

[dh58]

Originally Posted by totti84

You asked for the best, HFS4 is the best!

Coolingmist/BMS and Snow Performance are some other options

Thank you Yeah I thought others might have a different opinion on what is the best.

Thanks for the direction! I'm looking into it

[totti84]

Originally Posted by dh58

Thank you Yeah I thought others might have a different opinion on what is the best.

Thanks for the direction! I'm looking into it

Advan tank with Aquamist would be my suggestion, but far for cheap lol

[dh58]

Originally Posted by totti84

Advan tank with Aquamist would be my suggestion, but far for cheap lol

lol.. yeah expensive

[_ink]

Outside the controller, imo the lines, connectors and nozzles are just as important.

I have Advan stealth tank, braided lines with AN fittings, Devils own pump and Solenoid, and a level sensor in the tank.

I use the JB4 FSB to control it which is more than sufficient.

I will be parting this out soon as upgrading to PI. (But I'm a 3'er)

[martymil]

I wouldn't get rid of the meth setup with the PI kit, your still going to need it.

[dh58]

Originally Posted by _ink

Outside the controller, imo the lines, connectors and nozzles are just as important.

I have Advan stealth tank, braided lines with AN fittings, Devils own pump and Solenoid, and a level sensor in the tank.

I use the JB4 FSB to control it which is more than sufficient.

I will be parting this out soon as upgrading to PI. (But I'm a 3'er)

Good point man.. The lines, connectors and nozzles are important. What nozzles did you get?

[_ink]

Originally Posted by dh58

Good point man.. The lines, connectors and nozzles are important. What nozzles did you get?

I went with Devils own also.

[_ink]

Originally Posted by martymil

I wouldn't get rid of the meth setup with the PI kit, your still going to need it.

I may keep it and reduce it to 1 nozzle instead of 2, not 100% sure yet.

[martymil]

Originally Posted by _ink

I may keep it and reduce it to 1 nozzle instead of 2, not 100% sure yet.

I have the pi kit and going 3 nozzles for cooling not knock suppression.

With the PI kit you will make more down low and mid range power but also more heat, hence why I'm suggesting you keep it.