|
|
|
05-26-2010, 04:43 PM | #1 |
First Lieutenant
43
Rep 371
Posts |
Check engine light after afe intake and SSTT install
I got a check engine light after installing my AFE intake and SSTT chip. I had it last season and there were no issues or check engine lights. I have a regular OBDII scanner and the error stated it was a 02 sensor.I tried to erase the code but could not. I tried unplugging the battery and thought it might be because I did the golf tee mod but the check engine light does not go away. I'm not sure if that is an accurate reading. I don't know what the problem is and would appreciate any helpful advice from experienced users. If i can not find a fix then I'll have no choice but to buy a BT scan tool. NOTE: I have had long cranks (4-6 sec) for about 3 months now and I know that my HPFP will die anytime now. I floored my car after I installed the mods and notice that the car all of a suddenly jerked and lost power. I really just want this pump to fail and clear my codes. No more modding for me i have had bad experiences.
|
05-26-2010, 10:21 PM | #2 |
Lieutenant Colonel
86
Rep 1,609
Posts |
You will need a BT Scanner to clear the codes and the SEL will go away next time you start the car.
__________________
7/08 135 Coupe, Crimson Red, 6 SP, Sport, Taupe Lette/Aluminum. Performance Mods: JB4 on Map 5, BMS DP Fix V3, Injen polished intake, AR Catless DP, Maddad resonated mid-pipes, aFe exhaust polished tips, ST Suspension Coil Over and Hotchkis front sway bar. Others: BMS OCC, BT Scanner, Mud Flap. Next Mods: AA Front Strut Brace.
|
Appreciate
0
|
05-27-2010, 01:46 PM | #3 |
First Lieutenant
43
Rep 371
Posts |
Ya I just placed an order for a BT scanner. Hopefully that will solvey problems but I still don't understand why the CEL did not come on last time I installed it.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|