|
|
|
|
|
| 10-21-2014, 07:12 PM | #1 |
|
Major
 
1496
Rep 1,297
Posts |
bmw performance exhaust bolt on?
Trying to figure out if I need a shop to install does it bolt right up to 135 and does the stock exhaust get cut or altered in some way?
__________________
2022 M3 xDrive Comp
2020 M2 CS (retired) 2018 M3 Comp (retired) 2015 335i (retired) |
| 10-21-2014, 07:17 PM | #2 |
|
Major
340
Rep 1,293
Posts |
The PE come with the axle back and a resonator delete Y-pipe. You can bolt the axle back on without modification. If you want to install the Y-pipe (which most people think is a must) you need to cut the mid pipes just in front of the resonator.
|
|
Appreciate
0
|
| 10-21-2014, 07:18 PM | #3 |
|
European Editor
10532
Rep 22,992
Posts |
The PE kit comes with a y-pipe which deletes the mid pipe resonator. So yes, IF you install that. you need to cut off the old resonator and use the supplied clamps.
See post #90... http://www.1addicts.com/forums/showt...=797160&page=5 Dackel
__________________
|
|
Appreciate
0
|
| 10-22-2014, 08:41 AM | #4 |
|
Major
1496
Rep 1,297
Posts |
thanks pal, this helps a bunch
how easy/costly would it be to revert back to stock if i decide to sell car
__________________
2022 M3 xDrive Comp
2020 M2 CS (retired) 2018 M3 Comp (retired) 2015 335i (retired) |
|
Appreciate
0
|
| 10-24-2014, 02:40 PM | #5 |
|
New Member
2
Rep 21
Posts |
extremely easy although if you install the y-pipe then say good bye to the clamps (you will need those to re-install your original setup provided you kept it) of which BMW charges $122 to replace. Cost would be as cheap as buying a couple garage ramps to pull your car up on while you slide under and un-bolt.
|
|
Appreciate
0
|
Post Reply |
| Bookmarks |
|
|
