|
|
|
01-06-2014, 09:31 AM | #1 |
Lieutenant Colonel
118
Rep 1,668
Posts |
Battery Replacement
Well i have read many thread about the recoding after replacement of a battery in the 1 series. I might be a little confused about as to why this is needed since the battery is just a power supply.
I have a couple questions. 1. Why first of all is it necessary to code the car to the new battery? 2. What harm would there be if we didnt recode the car? This just seems strange to me. The manual says that there are convenience buttons that will need to be programmed. What convenience buttons are they talking about? Is there anyway around that like keeping the car powered up with a seperate battery while changing the battery in the trunk?
__________________
Enjoying an E89 Z4, F30 320i and Fiat Abarth //
E85 Z4 (sold), E82 128i (sold), Fiat Pop 500 (sold) |
01-06-2014, 09:42 AM | #2 |
CW2
27
Rep 440
Posts
Drives: 1SMC - traded away
Join Date: Sep 2010
Location: Pennsylvania
|
1. Charging of the battery is a delicate balance and the ECU needs specific data to ensure appropriate charging (i.e. specific amperage, etc.). This requires re-coding after installation so the ECU is aware of a "new" battery and/or any changes from the new battery (different CCA etc.).
2. Search any of the forums out there and you will see that there has been variable degrees of success NOT coding, but the consensus seems to be that re-coding will avoid premature battery drain/incorrect use from the ECU. I know, I know....it's mind-blowing that they've overengineered it to this extent, but the specific batteries in our vehicles (AGM) are different from your same ol' same ol' and aren't "wet" but a different composition and therefore vent less gas into the vehicle (bearing in mind that they really are IN the vehicle more or less). Best of luck. I am in the same situation and I'm infuriated that I can't just swap it out...
__________________
Good-bye, ol' Paint...
|
Appreciate
0
|
01-06-2014, 09:50 AM | #3 |
Private First Class
6
Rep 153
Posts |
I hate to pay a lot of money for a battery too. But my battery is still original and running like a top. The cheap batteries in my regular cars never last as long.
|
Appreciate
0
|
01-06-2014, 10:01 AM | #4 |
Lieutenant Colonel
118
Rep 1,668
Posts |
well i am not convienced that my battery is the culprit. I will start another therad on the symptoms. But just in case has anyone bought a battery from say Auto Zome or Advanced Auto Parts and then had it coded? Or does one have to buy a battery fro the manufacturer? (that would suck)
__________________
Enjoying an E89 Z4, F30 320i and Fiat Abarth //
E85 Z4 (sold), E82 128i (sold), Fiat Pop 500 (sold) |
Appreciate
0
|
01-06-2014, 02:26 PM | #5 | |
bimmerphile, technogeek
998
Rep 3,784
Posts
Drives: 2012 E82 6MT Sport
Join Date: Jun 2011
Location: SoCal
|
Quote:
EDIT: I just checked... My battery has the vent tube.
__________________
Last edited by bmw1racer; 01-06-2014 at 03:00 PM.. |
|
Appreciate
0
|
01-06-2014, 02:37 PM | #6 |
CW2
27
Rep 440
Posts
Drives: 1SMC - traded away
Join Date: Sep 2010
Location: Pennsylvania
|
Aren't the AGM types self-contained but not vented? I don't know. I'd have to check. My E30 and E83s didn't seem to be so complicated, and I know the E30 battery wasn't complicated!
__________________
Good-bye, ol' Paint...
|
Appreciate
0
|
01-06-2014, 10:42 PM | #7 |
Lieutenant
79
Rep 435
Posts |
AGM are also wet lead acid batteries....just in a different configuration. The 'vent' is not the same as in a flooded cell battery and is attached to a safety pressure valve that only opens under certain adverse conditions and not normally open to the atmosphere. I too would like to know what the "coding" accomplishes other than a trip to the dealer.
|
Appreciate
0
|
01-07-2014, 05:09 AM | #8 |
Lieutenant
262
Rep 561
Posts
Drives: '23 M5 Comp
Join Date: Mar 2008
Location: Columbia, TN
|
You can easily tell if you have an AGM battery by the color. Black = AGM, white = regular battery. My '10 has a regular battery, not an AGM.
I have to say that having to take your car to the dealer for "coding" a new battery to the car is pretty ridiculous... |
Appreciate
0
|
01-07-2014, 07:57 AM | #9 |
Private First Class
17
Rep 146
Posts |
You can buy a regular battery, but it still should be coded. At an INDY shop, they quoted me $300 total for the battery and coding. Frustrating, yes.
This isn't unique to BMW either, several new cars have it as well. Where's my oil dip stick?
__________________
Dave Gran
Free Guide to Motorsports AND Car Reviews from an Enthusiast's Perspective GoAheadTakeTheWheel.com |
Appreciate
0
|
01-07-2014, 07:59 AM | #10 |
but no flokka
523
Rep 717
Posts |
Has anyone gone to a lightweight battery? Just out of curiosity, my 09's original battery is still going strong.
|
Appreciate
0
|
01-07-2014, 10:11 AM | #11 |
Major
315
Rep 1,035
Posts |
I hear in Germany if you want to have sex with your wife and you want to rock a rubber you need to visit the BMW shop so they can code the robber to your dong or you may have some problems!
Which ever worthless engineer thougth of this needs to be found tied to his bed and beaten with baseball bats untill he can no longer walk or lift a finger ever again! I mean really....really really? Come on! Who thought of this and why has he not died yet? |
Appreciate
0
|
01-07-2014, 10:37 AM | #12 | |
Lieutenant Colonel
118
Rep 1,668
Posts |
Quote:
So, i get that a smart charging system can prevent over charging the battery thus cut cost down in the short term but when it cost $500 to replace a $140 battery then that is a little excessive. Simply put there is no reason except for self preservation on BMW stand point. While i cannot prove it i suspect that they added this feature so that no batteries would go bad before the service warranty runs out due to over charging or under charging etc. Let's say they prolonged the failure by another few months or even a year or so. That might get them off the hook for the cost of replacements and pass that buck to the people that buy the vehicles afterwards. The only problem i see with that philosophy is that if every used vehicles battery fails within the first year at a cost of $500 ppl will stop buying the vehicles used. Afterall when you get mom or pop or joey down the street that knows nothing about vehicles and has not done any reasearch when the battery goes and they have to take out half their mortgage payment to replace it, they might be saying to themselves what if an engine goes out would that cost me $10K? Oh wait, Joey yep it would after you pay for labor and coding yep it would. ok i am dont ranting here but i am still looking for other opinions on the matter. Maybe this coding thing is just a money suck only who knows. lets see what others say.
__________________
Enjoying an E89 Z4, F30 320i and Fiat Abarth //
E85 Z4 (sold), E82 128i (sold), Fiat Pop 500 (sold) |
|
Appreciate
0
|
01-07-2014, 11:53 AM | #13 |
First Lieutenant
43
Rep 347
Posts |
Buy the correct battery
buy the correct cable use the free software (and donate some $ to the guy who made it) http://www.e90post.com/forums/showthread.php?t=727091 I believe the e82 also has the MSD80 dme so it should work fine |
Appreciate
0
|
01-07-2014, 01:53 PM | #14 |
Second Lieutenant
8
Rep 216
Posts |
Umm that's incredibly useful! I think this might warrant a sticky!
__________________
2012 BMW 128i: BMW Performance Rear Spoiler, BMW Performance Front Grilles, 20% Tint, BMW 135i M-Sport Axle-back With Shadowline Tips, Golf-Tee Mod, 261 M-Sport Rims with Falken 235/40R18 265/35R18 Tires,Depo Smoked LED Side Makers, Eiback Pro Springs (To be installed) |
Appreciate
0
|
01-07-2014, 10:51 PM | #15 |
Lieutenant
79
Rep 435
Posts |
After too much research on the subject I'll add my .02......If your battery is replaced with an equivalent ah AGM or flooded cell battery coding does nothing but change the date of battery install and that is insignificant in the life and function of the battery with all other conditions constant (use/temperature). Information of limited value to you digitized in the car. The charging properties of AGM vs flooded cell car batteries is so similar as not to be a problem regardless of which one you choose. Interesting that flooded cell batteries in passenger cars, boats, and fixed installations are rated more reliable $ for $ than AGW. Black batteries in BMW = AGM (I didn't know that!). So installing an equivalent battery regardless of AGM or flooded cell and not 'registering' it should be no problem. Methinks the coding/registering is only important when intentionally increasing battery power due to usage needs (audio amp?) or installing a lower capacity battery which is not advised from a power requirements standpoint and it could shorten its' life. To me "smart charging" seems like nitrogen vs. atmosphere in tires when it comes to battery replacement. It could be extending battery life but that information isn't being released and from the reports of replacement I doubt it. I'd appreciate some real information other than "because BMW knows what's best for its' product" or "its' a complex system and requires it" to change my opinion.
|
Appreciate
0
|
01-08-2014, 05:51 AM | #16 |
Lieutenant
262
Rep 561
Posts
Drives: '23 M5 Comp
Join Date: Mar 2008
Location: Columbia, TN
|
It would be interesting to find out if owners out there have replaced the batteries without recoding and experienced ANY issues...
|
Appreciate
0
|
01-08-2014, 06:13 AM | #17 |
Major
189
Rep 1,026
Posts |
Based on what I have read, the main issue with changing an old battery with the same type of new battery, is your smart battery system charges and old battery different than a brand new battery, such that you may experience shortened battery life if you do not register a brand new battery.
|
Appreciate
0
|
01-08-2014, 02:48 PM | #18 |
CW2
27
Rep 440
Posts
Drives: 1SMC - traded away
Join Date: Sep 2010
Location: Pennsylvania
|
This was my understanding and it seems like folks have experienced this on other forums (3ers). Has anyone tried using AAA battery replacement? They claim to swap your battery as a complete job, and the 1 series is listed. I can easily swap a battery, but why pay for recoding if AAA has an OBD connector and can do it?
I doubt they do, and my heart tells me their program is not aware of the recode issue.
__________________
Good-bye, ol' Paint...
|
Appreciate
0
|
01-08-2014, 02:55 PM | #19 |
Brigadier General
368
Rep 3,547
Posts |
I did a google search today looking at what a battery costs for my 128i. I didn't see anything less than about $150 but I didn't look real long. On the same search, I got an add for my dealer saying they would replace the battery including registration for $175. There could be fine print that ruins this but it seems like the dealer can do this for a reasonable cost if they want to. Even though I can code, I'm not sure I would spend my time to save $25.
__________________
128i Convertible, MT, Alpine White, Black Top, Taupe Leatherette, Walnut, Sport
Ordered 5/22/09, Completed 6/4/09, At Port 6/9/09, On the Georgia Highway 6/13/09, Ship Arrived Charleston 6/24/09 at 10pm, PCD 7/21/09 |
Appreciate
0
|
01-08-2014, 03:21 PM | #20 | |
Lieutenant
79
Rep 435
Posts |
Quote:
|
|
Appreciate
0
|
01-08-2014, 04:01 PM | #21 | |
Major
189
Rep 1,026
Posts |
Quote:
2) No. 3). One would think. Last edited by Iron Man; 01-08-2014 at 06:31 PM.. |
|
Appreciate
0
|
01-08-2014, 05:06 PM | #22 |
New Member
2
Rep 21
Posts |
here´s an excerpt from the instructions given in "Rheingold" (couldn't copy/paste it but re-typed word by word):
"After installing a new battery, the service function "register battery replacement" must be run. the registration of the battery replacement is required to inform the power management (software in engine electronics and intelligent battery sensor) that a new battery was installed in the vehicle. If the battery replacement is not registered, the power management will not function properly and can lead to functions being limited by individual electrical consumers being switched off or having their power reduced, for example" "registering" as per the service instructions in "Rheingold" means that a battery with a different capacity must be coded into the CAS, as well as a change in battery type (lead-acid vs AGM), and the service function "Battery" must be run (ISTA/P) and the power management system be initialized. after the new battery is in, the vehicle must sit for at least 3 hours for the power management system and the battery to learn to like each other... so i think this sums up what has been said before: not registering might screw up the power management and the procedure may indeed be overengineered. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|