|
|
|
12-12-2017, 08:20 AM | #23 |
Sideways and Smiling
3027
Rep 2,860
Posts
Drives: In Exuberance
Join Date: Mar 2017
Location: Rosamond, CA USA
|
Track season's done here. If it were a bad bearing, it would have failed badly already, and I'd be giving my wheel a point-by. I'm definitely going to replace it/them before track season starts up again; 7k miles with this noise, and no real signs of significant damage, didn't feel a need to earlier. It has no play in it, and makes minimal noise under a stethoscope, starting to think it might be something else, again.
__________________
2012 BMW 328i 6-Speed Wagon | Deep Sea Blue with Grey Dakota Leather | Manual Swap, 330i Intake + Tune, 3.15 Helical LSD, Öhlins R&T
(SOLD) 2009 BMW 128i 6-Speed Coupé | Monaco Blue with Black Sensatec | chris_flies' 128i thread |
Appreciate
0
|
12-12-2017, 08:41 AM | #24 | |
Lieutenant
425
Rep 545
Posts |
Quote:
__________________
2011 BMW 135i ///M-Sport, DCT
Bilstein B12 kit, Dinan camber plates, M3 front control arms, Whiteline poly RSFB, MHD Stage 1, cp-e Charge Pipe, H&R Front sway bar, BMW performance diffuser Last edited by BimmerAg; 12-12-2017 at 10:47 AM.. |
|
Appreciate
0
|
12-12-2017, 10:07 AM | #25 |
Sideways and Smiling
3027
Rep 2,860
Posts
Drives: In Exuberance
Join Date: Mar 2017
Location: Rosamond, CA USA
|
Trust me, I will. I'll be so happy to be rid of this noise!
__________________
2012 BMW 328i 6-Speed Wagon | Deep Sea Blue with Grey Dakota Leather | Manual Swap, 330i Intake + Tune, 3.15 Helical LSD, Öhlins R&T
(SOLD) 2009 BMW 128i 6-Speed Coupé | Monaco Blue with Black Sensatec | chris_flies' 128i thread |
Appreciate
0
|
12-12-2017, 12:53 PM | #26 |
shmo
383
Rep 1,026
Posts |
would a bad bearing make my car pull to one side??
I don't know if dack or others remember my post on putting new rims and tires and aligment at dealer and still getting right pull.. but after reading this.. im gonna go check my bearings ;(
__________________
No sig
|
Appreciate
0
|
12-14-2017, 04:05 PM | #27 |
Second Lieutenant
47
Rep 208
Posts |
Mine never pulled to the side or had any discernable wobble. Just a roar. A horrible, horrible roar.....
|
Appreciate
0
|
12-14-2017, 04:08 PM | #28 | |
shmo
383
Rep 1,026
Posts |
Quote:
idk y my fuxckin car pulls.. its been aligned recently so idk.. and rims are not bent soo whatevs
__________________
No sig
|
|
Appreciate
0
|
03-25-2018, 11:06 PM | #30 |
Lieutenant
137
Rep 439
Posts |
Bumping this thread. My 128 has 43,000 miles and both rear wheel bearings are groaning. I got the car in the air and spun both rear wheels and sure enough they’re shot.
This is definitely premature. The car is on BMW Performance suspension with 17” BMW wheels, no track days. The car did spend one or two winters in Wisconsin (previous owner) but now lives in Arizona. The car is still under CPO until December so they better cover this. I’ll get the airbag done, too Anyone else go through bad rear wheel bearings with low miles? |
Appreciate
0
|
03-26-2018, 02:05 PM | #31 | |
Sideways and Smiling
3027
Rep 2,860
Posts
Drives: In Exuberance
Join Date: Mar 2017
Location: Rosamond, CA USA
|
Quote:
__________________
2012 BMW 328i 6-Speed Wagon | Deep Sea Blue with Grey Dakota Leather | Manual Swap, 330i Intake + Tune, 3.15 Helical LSD, Öhlins R&T
(SOLD) 2009 BMW 128i 6-Speed Coupé | Monaco Blue with Black Sensatec | chris_flies' 128i thread |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|