|
|
|
11-21-2013, 01:54 PM | #1 |
New Member
0
Rep 24
Posts |
Help with installing angle eyes BALLAST
I am trying to find out where to put the Ballast for my led angle eyes on a 09 135i so I do not mess up my lights thanks !
|
11-21-2013, 02:56 PM | #2 |
The Crowing
111
Rep 2,005
Posts |
I stuffed mine in there around everything the first time I installed them. They ended up falling behind the actuator and blew out the motor and igniter and light. Very expensive fix. So i went to the hardware store and got a foot of Velcro for $.99. I velcro'd them to the cover. They've held really good. I checked them a few weeks later and the Velcro didn't melt and didn't come off either the lid or the ballasts. I thought for sure with how hot they get it was going to end up melting.
__________________
2009 135i : BMS JB4 G5 ISO,CXRacing FMIC Kit,Injen Cold Air Intake,Evolution Raceworks Charge Pipe,Walboro Inline Fuel Pump, E85 BMS Backend Flash w/ 60% E85,BMS Meth injection (trunkmount),BMS dual meth nozzles,Spec stage 2+ clutch w/ steel SWFW,BMS Catless Downpipes,Berk Tech Race Axleback |
Appreciate
0
|
12-04-2013, 10:15 PM | #6 | |
The Crowing
111
Rep 2,005
Posts |
Quote:
__________________
2009 135i : BMS JB4 G5 ISO,CXRacing FMIC Kit,Injen Cold Air Intake,Evolution Raceworks Charge Pipe,Walboro Inline Fuel Pump, E85 BMS Backend Flash w/ 60% E85,BMS Meth injection (trunkmount),BMS dual meth nozzles,Spec stage 2+ clutch w/ steel SWFW,BMS Catless Downpipes,Berk Tech Race Axleback |
|
Appreciate
0
|
12-04-2013, 10:56 PM | #7 |
Captain
75
Rep 961
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|