|
|
|
01-22-2015, 06:28 PM | #1 |
Private First Class
23
Rep 152
Posts |
AG m590's
Selling my AG M590's. Ive only had them for a couple hundred miles but its time for them to go. The front specs are 19x8.5 ET 43 and rear is 19x8.5 rear ET 45. I have absolutely zero rubbing on the front and had very minor rubbing on the rear until i got my fenders trimmed. The wheels were custom ordered with those offsets from OEM concept. They are a quality wheel. Now on to the bad part. I am selling them because I noticed a knocking noise after a routine checkup I took it to my guy and he said that there was a tiny vibration through the wheel that could be solved by having the wheels milled down 4-6mm or run a spacer. This is only the rears the fronts are 100% good, I was quoted by a machining shop 400$ to have the milling done but since I was already on the fence about selling them I've decided to sell them. They come with 225/35/19 front and 255/35/19 rear Hankook Ventus v12 evo the k110 variant. I am asking 1200 obo lowballers will be ignored. I have attached a link with photos. Thanks pm me with any questions or text me for a quick response 818-eight35-7one28. Thanks Guys. Cam http://www.1addicts.com/forums/showt...php?p=17161326 |
01-30-2015, 10:10 AM | #3 |
Private
10
Rep 98
Posts |
man, I have been looking at this set for a while and was wondering about the offset rubbing issue.. if you were local I would be spending my tax refund on getting these babies milled and my fenders cut for these
glws
__________________
“There are two ways of constructing a software design: One way is to make it so simple that there are obviously no deficiencies, and the other way is to make it so complicated that there are no obvious deficiencies. The first method is far more difficult.”
- Sir Charles Antony Richard Hoare |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|