|
|
|
02-13-2013, 07:53 AM | #1 |
Wild Card
91
Rep 683
Posts |
Exhaust Gaskets
I purchased a full aftermarket exhaust (midpipe and axleback) and need some good exhaust gaskets. Are the aftermarket and OE gaskets the same size for both the downpipes to midpipes (2 gaskets) and the midpipe to axleback gasket (1 gasket)? I have found links for downpipe to midpipe gaskets, but not for midpipe to axleback. Anyone know of the part number or have a link for a good aftermarket one?
__________________
Show me a sane man and I will cure him for you. |
02-13-2013, 08:55 AM | #2 |
Captain
14
Rep 961
Posts |
It's been a couple years since i installed mine but i don't remember there being a gasket between the mid pipe and axle back sections. IIRC it just slips on and clamps.
__________________
"I'm not surprised you get along well with all the other neighbours. If you put fifty children with Down's syndrome in a room there is going to be a lot of hugging." David Thorne
|
Appreciate
0
|
02-13-2013, 09:46 AM | #3 |
Captain
34
Rep 604
Posts |
Not completely sure on the count, but I have these and like them:
http://www.ardesign.info/store/bmw/b...asket-kit.html |
Appreciate
0
|
02-13-2013, 10:18 AM | #4 |
Just one more taste...
566
Rep 2,011
Posts |
The midpipe to axleback is what is called a "donut gasket" that is a fibrous gasket that fits on the OD of the midpipe flange and fits in the ID of the axleback.
__________________
My Build Thread: Jet Black 6MT 128i with MSport
|
Appreciate
0
|
02-13-2013, 10:29 AM | #5 | |
Wild Card
91
Rep 683
Posts |
Quote:
__________________
Show me a sane man and I will cure him for you. Last edited by greensto; 02-13-2013 at 10:39 AM.. |
|
Appreciate
0
|
02-13-2013, 10:35 AM | #6 |
Just one more taste...
566
Rep 2,011
Posts |
I am pretty sure, assuming you can get the gasket off, it is reuseable. I dont have a P/N off hand however.
Edit: quick search on REALOEM found this PN: 02 Gasket ring 1 18117553130 $26.38
__________________
My Build Thread: Jet Black 6MT 128i with MSport
|
Appreciate
0
|
02-13-2013, 12:30 PM | #7 |
Wild Card
91
Rep 683
Posts |
Ok I have the stock donut ring that I can re-use and I have new downpipe gaskets. Anything else I would need to attach the midpipe to axleback? Any new bolts/springs and such?
__________________
Show me a sane man and I will cure him for you. |
Appreciate
0
|
02-13-2013, 12:41 PM | #8 |
Just one more taste...
566
Rep 2,011
Posts |
bolts and springs should be fine to reuse for the mid-to axleback. Not sure on the DP to mids though.
__________________
My Build Thread: Jet Black 6MT 128i with MSport
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|