|
|
|
09-29-2013, 07:21 AM | #3 |
!
701
Rep 3,268
Posts
Drives: 2010 128i
Join Date: Feb 2010
Location: Anacortes, WA
|
What is a "square rear" set up? Might help if you clarify. You mean stock rear wheels on all 4 corners?
__________________
____________________________ |
Appreciate
0
|
09-29-2013, 08:37 AM | #5 |
Colonel
198
Rep 2,239
Posts |
I've always wondered this myself.
offsets are 18x8.5 et 52 for oem wheels. I think they'd fit without issue, so long as you use spacers.
__________________
08 e93 335i MT
|
Appreciate
0
|
09-29-2013, 11:25 AM | #6 |
Major
30
Rep 1,364
Posts |
There was a thread about this a while back, and if i remember correctly the rears in the front rub, best way to know for sure take your car to a shop and have them put your rear in front, or have them measure.
|
Appreciate
0
|
09-29-2013, 11:39 AM | #7 |
NCOIC of Kickin It
78
Rep 946
Posts |
i did, i dont have any pictures, but i think i used like a 12 or 15mm spacer and lots of camber (maxed out vorschlag plates). before i maxed the plates i had almost 1" of tire sticking out past the fender, and the fender was restiing on the tire.
I wish i could help more, but it is possible. |
Appreciate
0
|
10-03-2013, 02:45 PM | #10 |
General
2045
Rep 25,989
Posts |
You'd need at least a 7mm spacer for them to fit.
__________________
VMR|Wheels | 714.442.7916 |
sales@velocitymotoring.com | www.velocitymotoring.com | facebook | flickr | Instagram |
Appreciate
0
|
Post Reply |
Bookmarks |
Tags |
oem wheels, rims, square setup, style 264, wheels |
|
|