Megan racing toe arms separated dust boosts

[titium]

I've had megan racing toe arms installed for the last 2 years or so. recently trying to diagnose noise from the rear so i pulled them out of the car.

turns out it wasn't the toe arms, they're still good from what i can tell (tight with no play).

however I've noticed the boots have come off the joints (see photos) now i imagine if i left this long enough dirt and water would get in and ruin the joints.

has anyone seen this before or have a solution?. it appears there's a recess where a spring clip could be used to hold the boot but it looks like this would be near impossible to install without disassembly of the rod ends...
[IMG]undefined[/IMG]

[Dmak]

is it possible to use something like safety wire to tie it up?

I have the same toe arms. is only one side of the boot that came off? all others ok? I should check mine too.

[titium]

Originally Posted by Dmak

is it possible to use something like safety wire to tie it up?

I have the same toe arms. is only one side of the boot that came off? all others ok? I should check mine too.

nope it's all of them. both sides both joints on both arms.

be hard to pick it up with the arms on the car.