|
|
|
02-12-2017, 12:58 AM | #1 |
Captain
198
Rep 684
Posts |
as the title states driving through the snow got the best of me and ripped both of my post cat oxygen sensors clean off, one i was able to connect again but the other one was done it ripped out the wiring and connector so a new o2 sensor doesnt just fix the issue.
is there a way i can remove the 2c9f code somehow. I run MHD you cant flash it out i doubt it. Do they have any repair kits of any sort?. honestly the check engine light bothers me so i would love to have it turned off somehow without spending to much... |
02-14-2017, 02:10 AM | #3 |
Major
327
Rep 960
Posts |
easiest and best solution is to just replace the sensors.
you can probably get rid of the codes in a tune but means you'll always need a custom tune. post cat 02s also make sure the pre cats o2s are working correctly |
Appreciate
0
|
02-15-2017, 12:49 AM | #4 |
Captain
198
Rep 684
Posts |
yea but its more to it then that becuase the wiring that goes to one of the sensors is ripped out pretty deep as well because i only see one wire where i imagine there should be 3 coming out of the harness that supplies the wiring and connector needed so that you can plug the o2 sensor in
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|