|
|
|
02-11-2015, 01:23 PM | #1 |
New Member
4
Rep 28
Posts |
Oem Cupholder Install Procedure
Hey Folks,
I just recently purchased a much needed cupholder for my 128i. i managed to get a very good OEM which somehow is connected to the center console on the passenger right. The only question i need help with is how do you install the darn thing? Looked the part over, no clue. Didn't want to disassemble the thing for fear of breaking it. I would greatly appreciate a DIY or even a listing of instructions on how to install this part. I thank all of you for looking and even better responding. Snoop |
02-11-2015, 01:25 PM | #2 | |
Private
8
Rep 99
Posts |
Quote:
|
|
Appreciate
0
|
02-11-2015, 01:48 PM | #3 |
New Member
9
Rep 29
Posts |
If this is a replacement cup holder and you already had one there, then @NicholasLacouture is right. Just pull up hard to get the existing one out.
If you are retro-fitting the passenger-side cup holder on a car that did not have one before it's a lot more complicated. The DIY thread on this topic is missing the photos, but is still accurate: http://www.1addicts.com/forums/showthread.php?t=224061 This thread shows the same process, but with additional complexity of using the cup holder for a GPS holder: http://www.1addicts.com/forums/showthread.php?t=490628 |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|