|
|
|
05-19-2012, 03:52 PM | #1 |
Lieutenant
99
Rep 508
Posts |
Dyno Day (400 Club)
Well, today I was able to attend a dyno day at a local speed shop and while I was hoping for a bit more I am pretty happy with my little bimmer. There were around 40 cars there with 95% of them being Mustangs, GTO's, G8, and TransAms. I was the only Euro car there with the exception of a E92 M that did not dyno. Not much attention was given to the car until I did my first pull then there were a ton of questions!
Anyways, my car is FBO (JB4) + Meth on 93oct. I added a can of NOS octane booster and was pretty happy cracking that 400hp mark. Meth add was cranked up to 60 for this pull. Alos, please discard the lower numbers as they were of a Mustang GT that ran just before me... LOG: Video Note: The 392rwhp & 423rwtq are the SAE numbers that they were using for everyone. I had them convert to STD to compare to what most use on the forums. From the looks of this I would benefit from the 15ohm mod. Also, I will add a few videos/photos later. Thanks for looking! Last edited by trickcruiser; 05-19-2012 at 05:16 PM.. Reason: Add Video |
05-19-2012, 04:10 PM | #2 |
Banned
247
Rep 1,827
Posts |
So basically its the same setup from when you ran a 12.4@114mph as shown here: http://www.1addicts.com/forums/showthread.php?t=686578 ?
Good results! |
Appreciate
0
|
05-19-2012, 05:13 PM | #3 | |
Lieutenant
99
Rep 508
Posts |
Quote:
This is the same basic setup. Thanks |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|