Looking for Apex Arc-8 18x8.5"/18x9.5"

[r0nd3L]

Looking for a set of Apex Arc-8 wheels in 1-series staggered fitment. Must be in great condition. I'm partial to Satin Black, but will entertain silver as well.

[Clovef]

I have as set with star specs that are close to new I would trade. They are silver and 3k miles with a 235/275. I am looking to go less stagarded or a square set up for a more playful rear end. Let me know if you have a set to trade or if you would want the whole setup.

[r0nd3L]

Originally Posted by Clovef

I have as set with star specs that are close to new I would trade. They are silver and 3k miles with a 235/275. I am looking to go less stagarded or a square set up for a more playful rear end. Let me know if you have a set to trade or if you would want the whole setup.

I was mostly looking for just wheels as I have RE11s ready to be mounted. Dunlops are a bit too noisy for me. Maybe you'd be interested in selling me the rear pair and then we can both buy pair of 8.5" from Apex?

[1&done]

What size are your RE11s? Only asking because if you plan to track you can get away w running 18x9s in the front, it's closer to a squared setup.

[r0nd3L]

Originally Posted by 1&done

What size are your RE11s? Only asking because if you plan to track you can get away w running 18x9s in the front, it's closer to a squared setup.

Not tracking this car in particular, but might see few autoxes. I couldn't find any 18x9 wheels. Alufelgen CS7 were the only ones, but they are backordered forever.

I was considering running 18x9.5" all around with 255. Might be tight fit, but with GC coils and camber plates, might just fit.

Any suggestions?

[1&done]

Depends on how wide the tire is. I am able to run a ARC 8 et 42 18x9 up front w a 255/35 Toyo R888. I have to run extreme neg. camber when I use them. The 9" wheel is under the e36 chassis on the website https://www.apexraceparts.com/mobile/home.asp?cat=11&#homeSubCat_14_1

I think the 9.5 square setup would be awesome but it's a gonna be tight up front I fun a 3mil spacer to keep the wheel off my strut tube, 5mil was too much w -2.2 camber, would have been ok at -3ish...I honestly don't think the 9.5 will for upfront, I'd search and see who's doing it. Maybe the 18x9 squared is a good option

My 255 PSSs fit nicely upfront on an 8.5" Breyton wheel. You could go that route...they are pretty light too.

[Expert@ApexWheels]

If you are looking for a new set, we do have the Satin Black ARC-8s currently in stock at this time, ready to ship immediately!

[1&done]

Originally Posted by David@ApexRaceParts

If you are looking for a new set, we do have the Satin Black ARC-8s currently in stock at this time, ready to ship immediately!

David what's the best way to reach you are someone w/ your company. I sent a PM to Eddie and an email to your company regarding hub rings. Can you PM me?