|
|
|
04-12-2017, 03:54 PM | #3 |
Lieutenant
104
Rep 486
Posts |
Pic 1 - Remove the center vent - circled in yellow(carefully, as the hazards, power locks, and DTC are wired to the rear).
Pic 2 - Start at the top edge and pull semi-downward, separating the edge in red from the edge in blue. Pic 3 & 4- You now have access to the front screws holding the housing, inside of the holes highlighted in orange. Pic 5 - My screen is already removed, but here highlighted in green, you can see the holes for the rear screws which can be accessed with the screen tilted partially upright.
__________________
|
Appreciate
1
berne45.50 |
04-12-2017, 05:10 PM | #4 | |
First Lieutenant
46
Rep 370
Posts |
Quote:
Thanks u so much.... now I can continue with the NBT, it was the green once, I didn't see |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|