|
|
|
10-19-2011, 12:39 PM | #23 |
Captain
168
Rep 773
Posts |
since the 4 and the 4s have the same form factor (body) then it should fit
All the iphone 4 cases work on a 4S Question is, can you fit a iphone with a case into this snap it module or does it have to be without the case ? Jeff |
Appreciate
0
|
10-19-2011, 02:25 PM | #24 |
Captain
35
Rep 609
Posts |
Definitely without the case. Just the naked phone.
__________________
NB8S Past Garage: Z4, 135i. Present Garage: 2013 X Drive X1 2.8i.
|
Appreciate
0
|
10-19-2011, 05:24 PM | #25 |
Lieutenant Colonel
136
Rep 1,592
Posts |
I was actually wonder if the adapter would work with my car, not if the phone would work with the adapter.
As I said I have an '08 135i. In the center console pictured above I have just a shallow plastic well. Can that be removed and the iPhone adapter installed in it's place? Or was is there some option I would have had to get when I purchased the car for this to work? I'd like to have the full snap in adapter, but if it requires a special option I don't have or would require a major install fee then I'll just stick with the Y cable and bluetooth. Dan |
Appreciate
0
|
10-19-2011, 07:31 PM | #26 | |
Captain
35
Rep 609
Posts |
Quote:
__________________
NB8S Past Garage: Z4, 135i. Present Garage: 2013 X Drive X1 2.8i.
|
|
Appreciate
0
|
10-19-2011, 07:38 PM | #27 | |
Lieutenant Colonel
136
Rep 1,592
Posts |
Quote:
Thanks for the info. When I get the phone I try it for a few days with the Y cable and if I hate it I'll call the dealer. Dan |
|
Appreciate
0
|
12-12-2011, 11:04 PM | #28 |
Registered
0
Rep 1
Posts |
I have a 02 x5 the car is outfitted with the capability to use bluetooth but doesn't have the hardware what do I have purchase to make it work? I've looked around but wasn't able to find anything useful... any suggestions?
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|