|
|
|
|
|
| 03-31-2014, 07:50 AM | #1 |
|
Private
 6
Rep 59
Posts |
Trouble with meth low boost
Just installed the BMS FSB kit. Cannot get above 14.5-14.9 psi on map 3, using 93 octane, settings are 60 meth scaling, 40 for additive.
During test meth engages and sprays. Terry said my timing is being pulled, may be low potency meth content (using boost juice 50/50). Using 93 octane (however the car did sit for a week and a half without being turned on with 75ish miles left in the tank). The methanol being used is from November Any suggestions? log 4.csv - 21.4 KB Last edited by jscheiner.09; 03-31-2014 at 08:15 AM.. |
| 04-01-2014, 09:34 AM | #2 |
|
Civil Rights Activist
115
Rep 949
Posts |
I'm not downloading the log from the shady download site, but if your timing is being pulled it's one of two reasons.
So go from there. Drain the tank and try again with new meth. I think you kind of answered your own question.
__________________
 E88 Crimson Red Vert MSport 6MT - Listing your mods in your signature is lame. BMS DCI/MHD E30 Flash!!/AA Sport FMIC/VRSF CP w Tial BOV/VRSF 3" DPs/550i clutch w SPEC SMFW/Apex EC-7s/Whiteline RSFB/E92 M3 FCAs/Bilstein B12 Pro Kit/VRSF inlets |
|
Appreciate
0
|
Post Reply |
| Bookmarks |
|
|
