|
|
|
|
Post Reply |
|
Thread Tools | Search this Thread |
04-01-2015, 02:00 AM | #1 |
Involuntarily BMW
31
Rep 184
Posts |
Part Identification: Plastic piece that connected front belly pan to the bumper
It's a piece that the bumper screws into from the bottom. I think it also has a few connections to the fender liner on each side. Mine cracked on one side when a fender liner broke, and I'm pretty sure it's not the belly pan.
It is a wide piece of plastic that is installed immediately in front of part #1 in this image: But I don't think it's in this image...
__________________
1997 328i / sold
1999 M3 / sold 2009 135i / current |
04-01-2015, 02:04 AM | #2 |
Involuntarily BMW
31
Rep 184
Posts |
Actually, looking at it...and comparing the front edge of part #1 to the bottom part in this picture it does look like the belly pan.
Rats.
__________________
1997 328i / sold
1999 M3 / sold 2009 135i / current |
Appreciate
0
|
04-01-2015, 06:33 AM | #3 |
1Addict
3230
Rep 7,889
Posts |
It's the front piece of the belly pan. Went through this myself not too long ago. I don't think they sell it separately. Sorry.
__________________
|
Appreciate
0
|
04-02-2015, 02:22 PM | #4 |
Wild Card
91
Rep 683
Posts |
They don't sell it separately. Bought mine from ECS since the first one I purchased didn't even have it. Save yourself the trouble and just get the right/complete one the first time.
__________________
Show me a sane man and I will cure him for you. |
Appreciate
0
|
04-03-2015, 06:20 PM | #5 |
Involuntarily BMW
31
Rep 184
Posts |
Rockauto is probably cheaper for this stuff... I'm just going to get some epoxy and bond mine. Mine is only slightly cracked and probably just needs some chicken wire reinforcement.
__________________
1997 328i / sold
1999 M3 / sold 2009 135i / current |
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|