|
|
|
03-08-2013, 09:17 PM | #1 |
Captain
32
Rep 644
Posts |
Lower bumper intercooler grill
I've searched with no luck. Is there a DIY for removing this grill?
Thanks
__________________
BSM 2008 135i
-VRSF 7" IC -VRSF DP's -n55 mids -BERK race -ER CP -TIAL BOV -BMS DCI -JB4 G5 ISO -ST coils -STOPTECH slotted rotors & pads -SLeK lip Follow me on instagram: wescuddles |
03-09-2013, 11:41 AM | #2 | |
Colonel
166
Rep 2,926
Posts |
Quote:
You can try to remove the bottom cover and go from underneath but it's a tough area to reach the top clips.
__________________
|
|
Appreciate
0
|
03-09-2013, 08:21 PM | #3 |
Internet Famous
5
Rep 232
Posts |
People have done it, but it looks like crap unless you sand down these little knobs that are left on the bumper after removal. Which means you should be prepared to have the bumper resprayed.
|
Appreciate
0
|
03-09-2013, 10:06 PM | #4 |
Captain
32
Rep 644
Posts |
Thanks guys
__________________
BSM 2008 135i
-VRSF 7" IC -VRSF DP's -n55 mids -BERK race -ER CP -TIAL BOV -BMS DCI -JB4 G5 ISO -ST coils -STOPTECH slotted rotors & pads -SLeK lip Follow me on instagram: wescuddles |
Appreciate
0
|
03-10-2013, 06:04 PM | #5 |
Captain
32
Rep 919
Posts |
I've done it- I personally like the look. It probably looks better with black, as the clips blend in better.
As far as a DIY, the grill is attached on the bumper with little pressure clips going all the way around. I strongly suggest you take the whole bumper off- it would be easier/faster to do this rather than trying to get under it, imo. |
Appreciate
0
|
03-10-2013, 08:18 PM | #6 | |
Captain
32
Rep 644
Posts |
Quote:
__________________
BSM 2008 135i
-VRSF 7" IC -VRSF DP's -n55 mids -BERK race -ER CP -TIAL BOV -BMS DCI -JB4 G5 ISO -ST coils -STOPTECH slotted rotors & pads -SLeK lip Follow me on instagram: wescuddles |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|