Sponsored by The Tire Rack

[Raffi]

Just installed a set of BBS CH-2 wheels that are 18x9.5 +38 and running BMS 10mm spacers up front to clear my coilovers, and decided to run 10mm spacers in the rear as well just to keep it uniform. Im not running extremely low, so I have not yet had any rubbing issues, front fenders have not yet been rolled, and alignment not done yet either.

Im simply posting to inform owners that it is possible. I understand it might not be appealing to everyone but I personally love the stance. Please excuse the the filthy car.

[VMRWheels]

Any rubbing issues? If so, how bad? Do you plan to camber the fronts at all?

Edit: Also, what size tires are you running on them?

[Raffi]

Originally Posted by VMRWheels

Any rubbing issues? If so, how bad? Do you plan to camber the fronts at all?

Edit: Also, what size tires are you running on them?

The rears would have some rubbing issues but the fenders were rolled from my previous set of wheels which were ccw classics 18x10.5 44 offset. The fronts haven't been rolled at all (yet), I am running camber plates which are 1 line to the negative. I say "1 line" because I don't know whether that equates to -1degree or not. The tires are 245/35/18 all four corners.

I live both in California as well as Arizona. In AZ, absolutely zero rubbing up front. In California, only on the aggressive entry driveways that seem to be everywhere. But I'm sure that will not be an issue when I get the front fenders rolled.

[e92ben]

Where did you get these!

[Raffi]

Originally Posted by e92ben

Where did you get these!

The wheels were from BBS Japan and according to BBS North America, were never available in the US. They were 5x114.3 that I had re-drilled.