Dyno'd my 2013

[kleach18]

Went to the somewhat local ADAC facility and got a few pulls in on three different maps.

2013 135i:
JB4 stage 2 ISO
BMS 3.5 inch DP
BMS n55 intake
CP-e charge pipe
BMW performance exhaust

Map 4: 355 hp - 346 lb/ft
Map 2: 374 hp - 420 lb/ft
Map 5: 387 hp - 448 lb/ft

It was on a LPS 3000 PKW dyno. I was told that it actually under rates power a bit, but it was very accurate..

I attached the dyno sheets but since I'm in Germany its all in German. I went and found a converter online and stuck the PS and N M and got HP and lb/ft.

The order of the runs were map 5, map 2, then map 4. He stuck the car in gear and let it drive itself on the dyno for about 10 to 15 minutes in between runs.

A quick video I stuck together of the runs... Sorry for so much background noise. I really need to get a mic for my GoPro.

[alexmtl_135i]

Is the blue line the stock power? If so that's some impressive gains for a N55

[kleach18]

The blue line is HP to the wheels and the higher red one is the flywheel measured on the left of the graph. The lower red one is torque measured in NM on the right of the graph. The green on the bottom is drivetrain loss.

My friend with N54 FBO ran yesterday and made 430 ps and 580 NM. I race him and beat him by about 1-1.5 car lengths. My car made 393 PS and 608 NM. It shows how torque makes more of a difference then HP.

[kleach18]

My friend also ran his 1M with DCI, Akrapovic exhaust, Chargepipe with upgraded diverter valves and made 393 PS and 590 NM of torque.

[GeeRam]

Originally Posted by alexmtl_135i

Is the blue line the stock power? If so that's some impressive gains for a N55

No, blue line (Radleistung) is the wheel horsepower figures, and the the green figures is the calculated run-down drivetrain loss.
The red Motorleistung value is the 'calculated' flywheel engine power figures.

Edit: got interruppted and beaten to it

[NORAGRETS]

you give me hope for my dyno my friend. im fbo but have yet to dyno...i have bmw ppk and hoping for cobb to release their ap for the 2012 n55 soon so i can go NutZ

[FOACAD]

Holy shit, all the way down in Fürth?

Damn...was hoping you found one closer than that.

Also, 355hp at the wheels on stock boost levels? Really? Are you running e85 at all?

[kleach18]

It's stock boost levels but still with the downpipes and everything. I was running 3 gallons of e85 on this tank.

Furth is only a 30 minute drive from me here in Bamberg.. The only other one I found was in Stuttgart that can measure more then 280 PS.

[Vtec Abuser]

Originally Posted by FOACAD

Holy shit, all the way down in Fürth?

Damn...was hoping you found one closer than that.

Also, 355hp at the wheels on stock boost levels? Really? Are you running e85 at all?

That is at the flywheel mate (unless I am wrong?).. WHP on that run is 283bhp..