|
|
|
03-08-2010, 02:03 PM | #1 |
Private First Class
12
Rep 128
Posts |
p2096 and p2270 after firmware update
i have rr catless downpipes & o2 sim, and jb3 1.4 i have had these mods for over a year and have had very few problems, a couple of codes when the temperature was below zero, that always went away.
i recently had my injectors replaced under warranty (due to long cranking), and since then i have had these two codes, p2096 and p2270. my ecu firmware was also updated at the same time by bmw. p2096 Post Catalyst Fuel Trim System Too Lean Bank 1 p2270 O2 Sensor Signal Biased/Stuck Lean Bank 1 Sensor 2 i checked the wiring on my rr o2 sim, and it was fine. i reset the codes after doing this, and then they reappeared immediately. i also upgraded to the newest control module for the jb3 (which upgraded me from jb1.3 to 1.4 as well) as a troubleshooting step, and that also did not help. the car has a slightly rough idle when cold, and will occasionally stumble under very light throttle as well (like cruise control). i am running on map 0 currently, and these code are still being thrown. i am not sure what else i can do. i have just ordered a bms o2 sim, maybe that will fix the problem. does anyone else have any other ideas? thank you. |
03-23-2010, 02:02 PM | #3 |
Private First Class
12
Rep 128
Posts |
I think I am getting closer to solving this, it does appear to all be o2 sim related.
I have purchased- upgraded jb3 control box ($110-50 core charge) replacement bms o2 simulator ($85) BT scan tool ($300) i am now fine tuning it, last adjustment i went 80 miles without a check engine light.. so i guess i am making progress but it cost a lot more than i thought it would. |
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|