|
|
|
12-29-2010, 09:58 AM | #1 |
Registered
1
Rep 3
Posts |
Does anyone know how to adjust the rear camber on 128?
Can anyone give a clear description, provide pictures or know of an existing forum discussion on this?
__________________
I had to slide to avoid a collision with
a woman who just heard that Michael Jackson died. |
12-29-2010, 07:01 PM | #2 |
H O O N
86
Rep 694
Posts |
The rear camber is adjusted by the inner eccentric bolt on the lower control/swing arm. You loosen the nut and rotate the bolt to get your desired camber setting then retighten the nut while holding the bolt in place. Theres a limited range of adjustment and once the bolt is rotated too far it'll start going back the other way.
Torque spec for this is 122ft-lb and takes a 21mm socket. Take a look at this thread : http://www.e90post.com/forums/showth...6R+springs+DIY In step 6-9 you can see which bolt I'm referring to, it's the inner one that connects the arm to the subframe Cheers, Ray
__________________
U WOT M8? |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|