04-06-2015, 06:46 AM | #1 |
New Member
1
Rep 12
Posts |
Miltek exhaust
Hi there
I have been offered a miltek primary cat back system. the only reason I really want to fit this exhaust is for sound. Would the car need a remap after the exhaust is fitted or will there be any error messages? Any help or advice would be great. Thanks David |
04-07-2015, 12:10 AM | #4 |
New Member
9
Rep 19
Posts |
I bought my car with a resonated milltek system the previous owner put on.
It sounded nice.. louder than stock, but not "exciting" enough for me. I ended up getting a new connecting pipe made up without the resonator at a reputable local muffler place (It was cheaper than buying the part from Milltek, and I didn't have to wait weeks to get it ..) Sounds amazing now, it's pretty loud but I wouldn't say obnoxious once the car is warmed up. Be warned - cold starts in the morning are LOUD and obnoxious https://www.youtube.com/watch?v=IO6Ztg9yNuQ |
Appreciate
0
|
04-07-2015, 08:04 AM | #5 | |
Lieutenant
439
Rep 574
Posts |
Quote:
In sound, yes. With a resonated system it will make it more berable on the motorway in regards to the drone but when you go wot it will still sound beautiful. I ran a full catless system and that was so loud, especially on startup, but it wasn't to bad when driving on the motorway, you just had to find the sweet spot. recently I just went and put a resonated section in and the loud rasp on start up has gone and the motorway driving is even better. It's a little bit quieter on WOT and not as many burbles but it's much better for everyday use in my opinion. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|