|
|
|
|
Post Reply |
|
Thread Tools | Search this Thread |
05-12-2013, 08:59 AM | #1 |
First Lieutenant
19
Rep 318
Posts |
Tricks to resetting brake alarm after new pad and sensor installed
I replaced my rear pads and sensor. After replacement I reset the trip computer and it worked. Rears went from -----km to 96000km.
After a couple weeks I got the alarm and the trip computer said replace rear pads in 1600km. I tried to reset it, hoping it would go back to ~96000km but instead it went to -----km and it also screwed up the front reading as well (also reads -----km). I believe this is a software issue. I tried resetting it a couple different ways people had suggested on-line with no luck. Haven't removed the calliper to see if there is rubbing but it's highly unlikely and when I stick my hand through the wheel I know it's installed correctly. Any suggestions (software wise)? Thanks |
Post Reply |
Bookmarks |
|
|