|
|
|
04-27-2018, 09:16 AM | #1 |
Private
20
Rep 62
Posts |
Engine Mechanical Question?????
OK so I had a cracked Valve cover on my 2013 135
Long story short.... Ordered it took the old off replaced with new car is now in LIMP MODE. The only codes the car is listing is TPS(Throttle Position Sensor) stuff. Low volt and high volt?? I took it back apart made sure i connected everything. Even took the intake side apart to make sure nothing was disconnected over there and i am still in LIMP MODE. Is this a dealer only fix??? Thanks in advance for any help!!!! FYI...car was running perfectly fine before the valve cover fix. |
04-30-2018, 04:04 AM | #2 |
Private
20
Rep 85
Posts |
Reset all adaptions. If that does not fix it check though the wiring to all sensors on the inlet side. Something may have not be plugged in or not plugged in correctly. Check for broken wires and or dirty contacts.
|
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|