BMW 1 Series Coupe Forum / 1 Series Convertible Forum (1M / tii / 135i / 128i / Coupe / Cabrio / Hatchback) (BMW E82 E88 128i 130i 135i)
 





 

Post Reply
 
Thread Tools Search this Thread
      03-16-2012, 05:24 PM   #1
Charles Kinbote
New Member
0
Rep
13
Posts

Drives: 2011 135i coupe 6MT
Join Date: Apr 2010
Location: a far off northern land

iTrader: (0)

Fitment question (yes, I've searched. . .

. . .but I haven't found a direct answer to my question.)

Hello, everyone--

I have an '11 135i with Sport Package and BMW Performance Suspension. I'd like to replace the stock wheels/tires with Michelin PSS (225/40/18 front and 255/35/18 back) on VMR V710 wheels.

Can anyone tell me definitively (ideally from first-hand experience) whether or not I'll experience rubbing? I'd rather not roll the fenders if I could avoid it.

Also, if you know that this setup will rub, can you suggest any alternative, comparable wheels and tires, or any solutions other than fender-rolling?

Thanks in advance!

CK

PS: Gill at Tire Rack wasn't able to give me a definitive answer and suggested I contact VMR. Haven't heard back from them, so I thought I'd bring it to the forum.
Appreciate 0
      03-16-2012, 06:54 PM   #2
tracer bullet
Brigadier General
tracer bullet's Avatar
United_States
2237
Rep
3,435
Posts

Drives: '11 135i , '15 X3 35i
Join Date: May 2011
Location: Saint Paul, MN

iTrader: (1)

When I got my car it had the 710's on it, 225/40 front and 245/40 rear, and they didn't rub. Can't say about the 255's on the rear.

I went to the Arc-8 wheels, Liked the looks and the offsets better. In retrospect it was a very small change and the 710's really do look good, if I did it again I wouldn't. If you have stock though, I would check them (Arc-8's) out. If you haven't already.

I have 265mm on my rears right now, and I wouldn't doubt there's room for more.

I have the stock 2011 suspension, your PS setup could differ here as I'm sure you know.
Appreciate 0
      03-16-2012, 07:20 PM   #3
Charles Kinbote
New Member
0
Rep
13
Posts

Drives: 2011 135i coupe 6MT
Join Date: Apr 2010
Location: a far off northern land

iTrader: (0)

Thanks, tracer bullet--

Yes, I have looked at the Arc-8 wheels, and they're sort of a Plan B in terms of my aesthetic preference--I agree with what you've written.

You also raise a point that others may be able to give me some guidance on: if I went with 245 tires in back, would there be any noticeable performance penalty--if this is minimal, I'd be willing to trade it for assurance that there would be no rubbing on V710 wheels.

CK
Appreciate 0
      03-16-2012, 08:23 PM   #4
Everfly
Brigadier General
Everfly's Avatar
154
Rep
3,143
Posts

Drives: BMW
Join Date: Apr 2011
Location: Indianapolis

iTrader: (51)

http://www.1addicts.com/forums/showthread.php?t=48120
Appreciate 0
      03-16-2012, 08:27 PM   #5
ModBargains IV
Second Lieutenant
ModBargains IV's Avatar
United_States
12
Rep
213
Posts

Drives: e92 335i, 135i, E46 M3, 540i
Join Date: Sep 2011
Location: 1721 E. Lambert Rd. Unit C, La Habra, CA 90631

iTrader: (1)

255s will probably rub if you plan to drop it.
Appreciate 0
      03-17-2012, 12:49 PM   #6
Charles Kinbote
New Member
0
Rep
13
Posts

Drives: 2011 135i coupe 6MT
Join Date: Apr 2010
Location: a far off northern land

iTrader: (0)

Quote:
Originally Posted by **********s IV View Post
255s will probably rub if you plan to drop it.
Hi--I don't plan to drop the car any further than the Performance Suspension already has. Would going to 245 tires in the rear help? Again, if the performance hit isn't significant I'd be willing to do this.

Also, Everfly, I didn't understand the link--can you clarify how it relates to my question? Thanks.

CK
Appreciate 0
      03-17-2012, 01:14 PM   #7
ModBargains IV
Second Lieutenant
ModBargains IV's Avatar
United_States
12
Rep
213
Posts

Drives: e92 335i, 135i, E46 M3, 540i
Join Date: Sep 2011
Location: 1721 E. Lambert Rd. Unit C, La Habra, CA 90631

iTrader: (1)

You will be fine with a 225/40/18 & 245/35/18

-Frank
Appreciate 0
      03-17-2012, 06:18 PM   #8
Eyeman
Colonel
Eyeman's Avatar
119
Rep
2,033
Posts

Drives: 2008 135 blk, blk, step
Join Date: Jan 2009
Location: Atlanta, GA

iTrader: (0)

Garage List
One thing that would slightly help is also mentioning what offset you plan to purchase. I'm guessing you are planning 18x8.5 et45fr, 18.9.5 et50r? That's what I'd do anyways. I think it will fit as you listed but I'd go ahead and order 245/35 rears for your first set just to be safe if those tires come in that size. If not, I'd order 255/35 before I ordered 245/40. Also, you should be able to get a little rear camber added if you do rub a little and you don't want to roll.

If you do rub a little it will be mainly be with extra weight such as passengers in the car.
__________________
Injen, RR OCC, MadDad Whisper, donut spare, 19x8.5et43fr 19x9.5et45r Volk LE37's, rear fenders rolled/pulled, PSS4S 225/35fr 255/30r, KW V1's, AR coated catless dps, Cross strutbar, CF grills and license plate holder, iCarbon diffuser, ETS black anodized FMIC, M3 control arms, Quaife, ER chargepipe, ForgeDV's, Topspeed Custom Tune, V3sims, Braille, Andrey_GTA rear hub mod, Ebay Mstyle front bumper and performance style side skirts.
Appreciate 0
      10-07-2012, 01:03 AM   #9
drew135i
New Member
0
Rep
8
Posts

Drives: BSM 135i
Join Date: Oct 2012
Location: Bay

iTrader: (0)

Charles, what did you end up getting?

I plan on getting 18x8.5 ET45 for the front, but conflicted between 18x9.5 ET45 vs ET 50 for the rear. The wheels I am getting are also VMR710. I was told if getting the ET45 for the rear, to match it with 245 tires, and if getting ET50, to match it with 255 tires. My question is, I plan on keeping the suspension stock (sport package) but would like to minimize the wheel gap. Which setup would be more ideal? Other suggestions? Thanks.
Appreciate 0
      10-07-2012, 09:21 AM   #10
TheBreeze
Lieutenant
United_States
255
Rep
494
Posts

Drives: 2016 F80
Join Date: Aug 2012
Location: Cary, NC

iTrader: (7)

Quote:
Originally Posted by drew135i View Post
Charles, what did you end up getting?

I plan on getting 18x8.5 ET45 for the front, but conflicted between 18x9.5 ET45 vs ET 50 for the rear. The wheels I am getting are also VMR710. I was told if getting the ET45 for the rear, to match it with 245 tires, and if getting ET50, to match it with 255 tires. My question is, I plan on keeping the suspension stock (sport package) but would like to minimize the wheel gap. Which setup would be more ideal? Other suggestions? Thanks.
I know the agony you are going through .. I went through a similar thing about a month ago. What wheels to get .. lamented on it for quite a while.

I'm running VMR701s 18x8.5/45 and 18x9.5/50 with a PSS 225/255 setup. At stock height I got no rubbing at all. I just installed a Dinan Stage I suspension which dropped the car maybe 3/4". I'm now rubbing on 3 corners when I hit dips at speed. I have an alignment scheduled in a few days, so we'll see if that takes care of any of the rubbing. If not, then I'll do a roll. The rubbing isn't that bad, but I'm going to get it perfect.

A few things to consider -

Michelin PSS run wider and shoulders are squarer than other brands, so they will rub where other tires won't. On the other hand, the beefiness lends to the appearance of filling the fender well. As far as street tires go, they are the best you can buy. Bridgestone S04s will give a little more room, and are also outstanding street tires. These were my very close second choice.

As far as offsets go, I would not get ET45s for the rear. ET50s sit pretty much flush, and that 5mm makes a huge difference getting the tire to tuck in under the fender like it should when you hit a bump. ET45s will extend out another 5mm, so a little outside of flush. Running 245s on a 9.5" wide rim would not be ideal at all .. for looks or handling. Also note that 245s are about 1/4" shorter than 255s, as well as the 225 fronts. If you're going to go with 245s for the rear, I'd stick to 215s on the front.

Here's some pictures I just took of my setup (crappy ugly day today so the pictures aren't the best) -








Last edited by TheBreeze; 10-07-2012 at 10:15 AM..
Appreciate 0
      10-07-2012, 09:25 AM   #11
Eyeman
Colonel
Eyeman's Avatar
119
Rep
2,033
Posts

Drives: 2008 135 blk, blk, step
Join Date: Jan 2009
Location: Atlanta, GA

iTrader: (0)

Garage List
I'd definitely get the et50 rear. A 255 tire is still a little stretched on a 9.5inch wide wheel. Even with the et50 you may rub a little with weight in the car depending on the tire brand you choose.
__________________
Injen, RR OCC, MadDad Whisper, donut spare, 19x8.5et43fr 19x9.5et45r Volk LE37's, rear fenders rolled/pulled, PSS4S 225/35fr 255/30r, KW V1's, AR coated catless dps, Cross strutbar, CF grills and license plate holder, iCarbon diffuser, ETS black anodized FMIC, M3 control arms, Quaife, ER chargepipe, ForgeDV's, Topspeed Custom Tune, V3sims, Braille, Andrey_GTA rear hub mod, Ebay Mstyle front bumper and performance style side skirts.
Appreciate 0
      10-07-2012, 03:43 PM   #12
drew135i
New Member
0
Rep
8
Posts

Drives: BSM 135i
Join Date: Oct 2012
Location: Bay

iTrader: (0)

Thanks the breeze. Your setup looks great. Do you have any pictures of your car before lowering? I plan to use the stock springs, so was wondering if that still leaves a big wheel gap with the same size wheels and tires as your setup.
Appreciate 0
      10-07-2012, 09:35 PM   #13
TheBreeze
Lieutenant
United_States
255
Rep
494
Posts

Drives: 2016 F80
Join Date: Aug 2012
Location: Cary, NC

iTrader: (7)

Quote:
Originally Posted by drew135i View Post
Thanks the breeze. Your setup looks great. Do you have any pictures of your car before lowering? I plan to use the stock springs, so was wondering if that still leaves a big wheel gap with the same size wheels and tires as your setup.
Here you go. This picture wasn't taken on flat ground but you can get a general idea. On flat ground there was the appearance of bit less of a gap than stock due mainly to the beefiness of the Michelins. The 225/255 setup is roughly the same tire height as the stock Bridgestone RE050 runflats, so what you have now will be pretty close to what you will end up with. The Dinan setup I used is actually a *very* mild drop. Maybe a little bit more than BMW yellow springs. My stock suspension was the Sport Package.

Appreciate 0
Post Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 03:59 AM.




1addicts
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST