Please Help - Adjust FOL via wheel controls

[bherbs]

Can anyone help, I don't know the series of commands to adjust my FOL through the wheel. I have looked through here and a few other forms and know it can be done just not how nor have I seen a guide.

I suspect it's too high as I was threw a couple codes immediately after adding meth to my 2012 135 6MT which seems eerily similar to what others have gotten, only they all use JB4 and what happened to them happened to me until they adjusted FOL - which you can adjust with the JB4 I take it.

I have cobb and the car is getting dyno tuned in 2 weeks with a specific map for meth but until then if I can adjust the value down a little I should stop popping codes and having it run pig rich at higher RPMs.

I have switched to the smallest (250cc) nozzle and have the controller set to deliver minimal meth which has helped but I'd like to try this if it's possible.

Any assistance would be much appreciated! Thanks everyone!

[inevitab1e]

Can't adjust FOL through the steering wheel with JB4. Have to do it under User Adjustments.

Since you're Cobb, did you ask them? I doubt you can do it via the steering wheel.

[Matticus91]

All I can offer:

http://www.n54tech.com/forums/showthread.php?t=17800