|
|
|
05-03-2013, 01:37 PM | #1 |
Colonel
172
Rep 2,347
Posts |
DIY request rieger rear
I want to install this diffusor but I don't read German and I want it to be perfect is anyone out there that can help ?
__________________
Mods:-Berkexhaust -alpinaB3flash -CobbAP -Cobb FMIC -ER charge pipe tialQ bov -M3 front sway bar -M3 subframe bushings -M3 front upper and lower control arms -M3 guide rods -M3 rear upper control arms -Mfactory LSD -defiv lockdown kit -TC Kline SA coilovers /camber plates- HP rear toe arms |
05-03-2013, 01:47 PM | #2 |
Major
170
Rep 1,215
Posts |
you just have to install it like every other diffusor.
there are screws under the diffusor and clips above the diffusor. then you pull the old one out and put the new one in, same process. but then it comes to the outter fins. you see 2 marked spots on each side where you have to drill. that`s all!
__________________
MANHART MH2 400 Partout FS: MANHART MHtronik Tuning Box http://www.2addicts.com/forums/showt...5#post18819345 |
Appreciate
0
|
05-08-2013, 08:10 AM | #3 |
Major
111
Rep 1,487
Posts |
Drill the inner liner of the rear bumper for the side fins and the use the screws provided. You can drill all four but actually two holds it firmly in place.
Easy job, like 45mins at best if you sit around a bit and have a beer. |
Appreciate
0
|
05-08-2013, 08:36 AM | #4 | |
Colonel
172
Rep 2,347
Posts |
Thanks guys
Quote:
http://www.1addicts.com/forums/showthread.php?t=836774
__________________
Mods:-Berkexhaust -alpinaB3flash -CobbAP -Cobb FMIC -ER charge pipe tialQ bov -M3 front sway bar -M3 subframe bushings -M3 front upper and lower control arms -M3 guide rods -M3 rear upper control arms -Mfactory LSD -defiv lockdown kit -TC Kline SA coilovers /camber plates- HP rear toe arms |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|